To Next PageTo Next Page
Need help?Do you have a question about the Kenmore 33125 - Power Miser 12 and is the answer not in the manual?
General| Brand | Kenmore |
|---|---|
| Model | 33125 - Power Miser 12 |
| Category | Water Heater |
| Language | English |
Warnings about fire, explosion risks, and severe burn hazards from hot water.
Dangers of carbon monoxide gas and requirements for proper ventilation.
List of abbreviations used throughout the manual.
List of materials recommended for installation.
List of basic tools required for installation.
Tools required specifically for sweat soldering operations.
Diagram and labels identifying water heater components.
Diagram of the thermostat and gas control knob.
Diagram of the pilot and main burner assembly.
Step-by-step guide to removing the existing water heater.
Warning about potential property damage from leaks and the need for drainage.
Precautions against fire and explosion from flammable vapors, liquids, and installation location.
Risks associated with carbon monoxide gas, insufficient ventilation, and insulation blanket installation.
Guidelines for providing combustion air in unconfined spaces.
Guidelines for providing combustion air in confined spaces.
Details on the temperature-pressure relief valve installation.
Instructions for insulating hot and cold water pipes.
How to operate and check the temperature-pressure relief valve.
Instructions on how to drain the water heater tank.
Steps for filling the water heater tank with water before operation.
Instructions and safety precautions for installing the vent system.
Crucial safety warnings to read before attempting to light the pilot.
Step-by-step guide for lighting the water heater pilot and burner.
Procedures for cleaning sediment from the tank and inspecting the vent system.
How to inspect the burner flame for proper operation and safety.
Steps to remove and reinstall the burner door assembly for service.
Guide on how to replace the pilot assembly on the water heater.
Steps to replace the thermocouple for proper pilot operation.
How to inspect and clean the flame arrestor and combustion chamber.
Detailed steps to reinstall the burner door assembly.
Description and testing of the piezoelectric igniter system.
Steps for removing and replacing the gas control valve/thermostat.
Recommendations for cleaning and inspecting the anode rod.
How to operate and check the temperature-pressure relief valve.
Procedures for draining the tank and replacing the drain valve washer.
Common issues encountered during startup and thermal expansion.
Possible causes and explanations for unusual sounds from the heater.
Explanation of condensation, smoke, and odor issues and their causes.
Causes of smelly water and the potential hazard of hydrogen gas.
Explanation of the high temperature shutoff system and its operation.
Troubleshooting steps for burner and pilot light ignition problems.
Troubleshooting steps for insufficient hot water and slow recovery.
Troubleshooting steps for high operating costs and smelly water.
Troubleshooting steps for relief valve drips and thermostat failures.
Troubleshooting steps for combustion odors, smoking, and sooting.
Troubleshooting steps for burner flame problems and small pilot flames.
Details of the limited warranty coverage for the water heater.
How to obtain warranty service for the water heater.
Information on Sears professional installation services.
