SECTION 2. PREPARE YOUR MACHIN6;.!P-O_fNG
Prepare the Bobbin (Continued)
• Insert the Bobbin into the Bobbin Holder
1. Put the bobbin into the bobbin
holder so that the thread feeds
counter clockwise (left).
2. Pu(( about 4 inches of thread
toward you through the tension
slot @.
3. Then pull the thread clockwise
toward the back of the machine
through the slot _
@
4.
Sbde the bobbin cover plate whil
pushing it down slightly over t_
bobbin. Allow about 4 inchesl
thread to show above the nee_
plate.
Threading
rt
• Threading chart is located behind
the face cover plate.
16
To Next Page
Loading...
