Installing Your Refrigerator
How to Remove the Doors and Hinges ,,+,z,,:,_1_,_
"_ Detach main wire connector harness.
r'l_J (dJspensillgt m°dels °nly) _, ,I,
• Use a flat blade screwdriver ,X,_!_I__
or fingernail to press junction __
point between two connectors _'_f
to release. _- -
Detach red wire harness
(some modeIs).
Press tab on underside of
connector to release,
Remove top hinges along . _../f_ _;:' ]
with doors. --_=/ U_>I
)
z 3/, ,, hex head driver. /
Z
How to Replace the Doors
• To replace doors, reconnect wiring harnesses and attach parts in reverse order from removal steps.
How to Install and Remove Handles
Handles are located within refrigerator section of refrigerator. Trim is located within the literature pack.
"-'°11,'- q
screws from bottom of I[I, i l
To r_mo*e" _ after initi_d" installation...,
Snap off trim from handle bottoms and unscrew exposed
screws.
NOTE: Fit may be tight. When removing handle, pull up and
out.
To Next Page
Loading...
