How to fix Kenmore Humidifier displaying alternating CF and room humidity?
If your Kenmore Humidifier is displaying alternating “CF” and room humidity, it means the filter may be dirty. You should replace the filter.
Why Kenmore Humidifier has poor evaporation of water?
Poor evaporation of water in your Kenmore Humidifier can happen if the check filter message “CF” is flashing or there's mineral buildup on the filter. Replace the filter with a fresh one. Note that local water purity varies.
What to do if Kenmore 758.154200 fan is not working but the display is on?
If the fan isn't running but the digital display is illuminated, it could be that the room humidity level isn't 3% or more below the set humidity level, or the reservoir is empty. Try raising the set humidity level, increasing the fan speed, and filling the humidifier with water.
How to turn on Kenmore 758.154200 if the digital display is not illuminated?
If the digital display is not illuminated, it could be due to no power or the power button not being pressed. Check the 120-volt power source and press the power button once to turn the humidifier on.
What does it mean when my Kenmore 758.154200 Humidifier displays alternating F and room humidity?
If your Kenmore Humidifier is displaying alternating “F” and room humidity, it means the reservoir is empty. Fill the humidifier with water.
Why won't my Kenmore Humidifier shut off, the fan keeps running?
If the fan is running continuously and the unit won't shut off, the float might be obstructed, the set humidity level is at 65%, or the room humidity level hasn't reached 1% or more above the set humidity level. Try freeing the float from any obstruction. Note that a set humidity percentage of 65% operates the fan continuously, so adjust the set level between 25% - 60%. Also, allow up to 48 hours initially for the desired humidity level to be achieved.
Why do the bottles continue to empty on my Kenmore 758.154200 Humidifier?
If the bottles continue to empty, it could be that air is entering the water bottle. Check the “E-Z-Fill Side-Caps” and valve assembly caps to ensure they are tight.
Why is the refill display 'F' on my Kenmore Humidifier before the bottles are empty?
If the refill display “F” is on before the bottles are empty, the unit might not be set up on a level surface, preventing the float from sensing the water. Position the unit on a level surface. Consider installing caster pads under the front casters, as some carpet padding may allow the unit to sit lower at the front.
Why are neither of the bottles emptying in my Kenmore 758.154200?
If neither bottle is emptying, it could be due to the bottle cap plunger missing the post in the bottom of the cabinet or dirty filters. Check the orientation of the bottles, repositioning them so that the bottle cap plunger (stem) is depressed by the post in the bottom of the cabinet. You may also need to change to fresh, new filters.
Why is the fan on my Kenmore Humidifier running slower than the speed on the display?
If the fan is operating slower than the speed registered on the digital display, the humidifier may be in “Dry Out Mode”. The humidifier automatically switches the fan to (WHISPER) F1 when “F” is flashing.
Defines DANGER, WARNING, and CAUTION to convey hazard levels.
General| Model Number | 758.154200 |
|---|---|
| Type | Evaporative |
| Runtime | 24 hours |
| Humidistat | Yes |
| Filter Type | Wick Filter |
| Speeds | 3 |
To Next Page