Why is my Kenmore Humidifier fan running continuously?
The Kenmore Humidifier fan might run continuously if the SET humidity level is at 65%. Adjust the SET level to between 25% and 60%. Also, the fan will run until the ROOM humidity level reaches 1% or more above the SET humidity level, which may initially take up to 48 hours.
What to do if my Kenmore 758.17006 Humidifier displays alternating “CF” and room humidity?
If your Kenmore Humidifier is displaying an alternating “CF” and room humidity, it could mean the filter is dirty. Try replacing the filter. If the issue persists, unplug the unit for 30 seconds and then plug it back in.
What to do if my Kenmore Humidifier displays alternating “F” and room humidity?
If your Kenmore Humidifier is displaying an alternating “F” and room humidity, it means the reservoir is empty. Refill the humidifier with water.
What to do if my Kenmore 758.17006 Humidifier fan is not operating but the digital display is illuminated?
If the fan is not working but the digital display is illuminated, the room humidity level may not be 3% below the set humidity level. Try raising the SET humidity level or increasing the fan speed. Also, ensure the reservoir is filled with water.
Why is my Kenmore 758.17006 bottle not emptying?
If the bottle is not emptying, the spring valve assembly might be damaged, or the post in the bottom of the base might be missing. Also, the base could be full of water. Check the bottle's orientation and reposition it so the fill valve is depressed by the post in the base. The base holds 1.25 gallons, so let the humidifier run to deplete the water from the base.
Why is my Kenmore Humidifier fan operating slower than the speed registered on the digital display?
If the fan is operating slower than the speed shown on the display, the humidifier may be in “DRY OUT MODE”. In this mode, the humidifier automatically switches the fan to low speed (F1) when “F” and the alternating room humidity are displayed.
How to fix a Kenmore 758.17006 bottle that continues to empty after complete filling?
If the bottle continues to empty after being completely filled, it indicates that air is entering the water bottle. Check the water bottle for any leaks.
What to do if Kenmore 758.17006 is not shutting off during “DRY OUT MODE”?
If the humidifier doesn’t shut off during “DRY OUT MODE”, it is likely because the filter is not yet dry. The humidifier will continue to run on low speed for up to 2 hours, or until the filter is completely dry.
Why is my Kenmore Humidifier digital display not illuminated?
If the digital display is not illuminated, it could be due to a lack of power or because the power button has not been pressed. Check the 120-volt power source and press the power button once to turn the unit on.
Why does my Kenmore Humidifier bottle empties completely?
This is normal for the initial filling. Refill the bottle for maximum run time.
General| Model Number | 758.17006 |
|---|---|
| Brand | Kenmore |
| Type | Console Humidifier |
| Humidistat | Yes |
| Filter Type | Wick |
| Speeds | 3 |
| Filter Required | Yes |
| Power Source | AC |
To Next Page