Kenmore 79048079000 - User Manual

iNSTALLATiON AND SERVICE MUST BE PERFORMED BY A QUALiFiED
iNSTALLER, iMPORTANT: SAVE FOR LOCAL ELECTRICAL iNSPECTOR'S USE.
READ AND SAVE THESE iNSTRUCTiONS FOR FUTURE REFERENCE.
FOR YOUR SAFETY: Do nat store or use gasollne or other flammable
vapors and liquids in the vicinity of this or any other appliance.
Your new wall oven has been designed to fit a limited variety of cutout sizes to make
the jab of installlng easier. The first step of your installatlon should be to measure your
current cutout dimensions and compare them to the cutout dimensions chart below far
your model. You may find lltfle or no cabinet work being necessary.
United States
Canada
Do not remove spacers (if equipped) on the side walls and/or an the back of the
built-ln oven. These spacers center the oven in the space provided. The oven must be centered to
prevent excess heat buildup that may result in heat damage or fire.
NOTES:
|. Bose must be capable of supporting 150 pounds (68 kg) for 27" models
and 200 pounds (90 kg) for 30" models.
2. Allow at least 21" (53.3cm) clearance in front of oven for door 1" (2.5 cm)
depth when it is open. Min.
3. Dimension G (cutout depth) is critical <L
to the proper installation of the built-
in oven. If the oven decorative trim
does not butt against the cabinet, or if I H
noise is heard on convection models, B |
verify dimension G to assure it is the I
required depth, t
4. For o cutout height greater
than 2713/16" (70.6cm) odd ......._ 31"*
i| . . ._--'"
one 2 (5cm) wide wood shim Doc)r Open
of appropriate height to each
(see note 2
side of the opening under the
appliance side roiis.
Suggested distance from floor
is 31" (78.7cm).
Minimum required distance is 4 1/2" (11.4cm)
Figure |
27" and 30" Single Wall Ovens (Double ovens see Figure 2)
2" (5 crn) Wide Wood
Spacer if Needed
Elecfrlcal
Junction Box
27" (68.6cm) 27 (68.6) 29t/16(73.8) 24s/8 (62.5) 241/2 (62.2)
30" (76.2cm) 30 (76.2) 29t/16(73.8) 28t/4 (71.8) 241/2 (62.2)
CUTOUT DIMENSIONS AND CABINET WIDTH
F H
MODEL G (rain.) I
Min. Max. Min. Max.
27" (68.6cm) 247/8 (63.2) 251/4(64.1) 231/2(59.7) 275/_ (69.4) 281/2(72.4) 271/8 (68.9) Min.
30" (76.2cm) 281/2(72.4) 29 (73.7) 231/2(59.7) 275/_ (69.4) 281/2(72.4) 301/8 (76.5) Min.
Aii dimensions ore in inches (cm).
Printed in United States
P/N 318201544 (1005) Rev. A
English - pages 1-8
Espa_ol - p6ginas 9-16

Summary

Product Dimensions

Cutout Dimensions and Cabinet Width

Details on cutout dimensions and cabinet width for models.

Installation Preparation and Safety

Installer and Consumer Notes

Important notes for installers and consumers regarding installation and future reference.

General Safety Instructions

Essential safety warnings for electrical hazards, operation, and preventing injury.

Carpentry and Cabinet Requirements

Requirements for cabinet support, clearances, and preparation for oven installation.

Electrical Requirements and Connection

Electrical Requirements

Details on voltage, frequency, circuit protection, and wiring standards.

Electrical Connection Procedure

Step-by-step guide for making electrical connections, including grounding.

Cabinet Installation and Securing

Cabinet Installation Steps

Procedure for inserting the oven into the cabinet opening and securing it.

Install Anti-tip Mounting Screws

Instructions for installing anti-tip hardware to prevent oven tipping.

Install the Bottom Trim

Steps for attaching the bottom trim piece to the oven.

Advanced Installation and Final Checks

Under Counter Installation

Diagram and dimensions for typical under counter installation with a cooktop.

Leveling the Wall Oven

Guidance on using shims to ensure the oven is properly leveled.

Checking Operation and Service

Verifying oven functions and troubleshooting tips before calling for service.

Kenmore 79048079000 Specifications

General

Brand	Kenmore
Model	79048079000
Category	Oven
Language	English