Kenmore 79048083000 - User Manual

To Next Page

iNSTALLATiON AND SERVICE MUST BE PERFORMED BY A QUALiFiED

iNSTALLER, iMPORTANT: SAVE FOR LOCAL ELECTRICAL iNSPECTOR'S USE.

READ AND SAVE THESE iNSTRUCTiONS FOR FUTURE REFERENCE.

FOR YOUR SAFETY: Do nat store or use gasollne or other flammable

vapors and liquids in the vicinity of this or any other appliance.

Your new wall oven has been designed to fit a limited variety of cutout sizes to make

the jab of installlng easier. The first step of your installatlon should be to measure your

current cutout dimensions and compare them to the cutout dimensions chart below far

your model. You may find lltfle or no cabinet work being necessary.

United States

Canada

Do not remove spacers (if equipped) on the side walls and/or an the back of the

built-ln oven. These spacers center the oven in the space provided. The oven must be centered to

prevent excess heat buildup that may result in heat damage or fire.

NOTES:

|. Bose must be capable of supporting 150 pounds (68 kg) for 27" models

and 200 pounds (90 kg) for 30" models.

2. Allow at least 21" (53.3cm) clearance in front of oven for door 1" (2.5 cm)

depth when it is open. Min.

3. Dimension G (cutout depth) is critical <L

to the proper installation of the built-

in oven. If the oven decorative trim

does not butt against the cabinet, or if I H

noise is heard on convection models, B |

verify dimension G to assure it is the I

required depth, t

4. For o cutout height greater

than 2713/16" (70.6cm) odd ......._ 31"*

i| . . ._--'"

one 2 (5cm) wide wood shim Doc)r Open

of appropriate height to each

(see note 2

side of the opening under the

appliance side roiis.

Suggested distance from floor

is 31" (78.7cm).

Minimum required distance is 4 1/2" (11.4cm)

Figure |

27" and 30" Single Wall Ovens (Double ovens see Figure 2)

2" (5 crn) Wide Wood

Spacer if Needed

Elecfrlcal

Junction Box

27" (68.6cm) 27 (68.6) 29t/16(73.8) 24s/8 (62.5) 241/2 (62.2)

30" (76.2cm) 30 (76.2) 29t/16(73.8) 28t/4 (71.8) 241/2 (62.2)

CUTOUT DIMENSIONS AND CABINET WIDTH

F H

MODEL G (rain.) I

Min. Max. Min. Max.

27" (68.6cm) 247/8 (63.2) 251/4(64.1) 231/2(59.7) 275/_ (69.4) 281/2(72.4) 271/8 (68.9) Min.

30" (76.2cm) 281/2(72.4) 29 (73.7) 231/2(59.7) 275/_ (69.4) 281/2(72.4) 301/8 (76.5) Min.

Aii dimensions ore in inches (cm).

Printed in United States

P/N 318201544 (1005) Rev. A

English - pages 1-8

Espa_ol - p6ginas 9-16

Main Page

Need help?

Do you have a question about the Kenmore 79048083000 and is the answer not in the manual?

Summary

Safety Warnings

Flammable Vapors Warning

Warning against storing or using flammable liquids near the appliance.

Spacers and Heat Buildup Warning

Warning not to remove oven spacers to prevent heat damage.

Installation Notes

Installer Notes

Instructions for the installer regarding electrical codes and preparation.

Consumer Note

Advice for the consumer to keep installation instructions for future reference.

Electrical Requirements and Connection

Electrical Requirements

Details on required voltage, frequency, and circuit protection for the appliance.

Electrical Connection

Guidance on connecting the appliance, including grounding and wire compatibility.

Cabinet and Anti-Tip Installation

Cabinet Installation

Instructions for inserting the oven into the cabinet opening and securing it.

Anti-tip Mounting Screws

Procedure for installing anti-tip screws to prevent oven tipping.

Oven Leveling and Operation Check

Leveling the Wall Oven

Steps to ensure the oven is level using racks and wood shims if necessary.

Checking Operation

Verifying the electronic oven controls function correctly after installation.