Need help?Do you have a question about the Kenmore 796.8027.900 and is the answer not in the manual?
Details on connecting the power cord for 4-wire and 3-wire configurations.
Instructions for connecting the gas supply pipe, including natural and LP gas.
Procedure to measure resistance of the thermal cut-off for electric dryers.
Procedure to test the auto-reset hi-limit thermostat by measuring resistance.
Procedure to test the auto-reset outlet thermostat by measuring resistance.
Procedure to test the lamp holder by measuring resistance.
Procedure to test the door switch by measuring resistance in different states.
Procedure to test the idler switch by measuring resistance when open and closed.
Procedure to test the heater by measuring resistance across its terminals.
Procedure to test the thermistor by measuring resistance at different temperatures.
Refer to MOTOR DIAGRAM AND SCHEMATIC for motor testing procedures.
Procedure to test the gas valve by measuring resistance of its terminals.
Procedure to test the igniter by measuring its resistance.
Procedure to test the frame detect component at different temperature thresholds.
Procedure to test the gas type hi-limit thermostat at specified temperature points.
Procedure to test the manual reset thermal cut-off for gas type dryers.
Diagrams and explanation of centrifugal switch operation in stop and run modes.
Layout of the Printed Wiring Board (PWB) for the display section.
Layout of the Printed Wiring Board (PWB) for the main control section.
Wiring schematic for electric dryer models.
Wiring schematic for gas dryer models.
Steps to enter the diagnostic test mode on the dryer.
Procedure to check 120V AC electrical supply at various points in the dryer.
Procedure to measure thermistor resistance with the power off.
Procedure to test motor operation, resistance, and related components.
Procedure to test the moisture sensor by measuring resistance and continuity.
Procedure to test the door switch and light bulb/socket components.
Procedure to test the heater switch and related components for electric models.
Procedure to test the gas valve, flame sensor, and ignitor for gas dryers.
Details on connecting tab relays with heaters (electric) and burners (gas).
Describes correct connection status modes for tab relays and PCB.
Identifies incorrect connection statuses for tab relays and PCB for electric and gas dryers.
Instructions for setting the gas valve for natural or propane gas.
Procedure for changing the gas orifice between natural and propane gas.
Steps to remove the top plate of the dryer.
Steps to disassemble the dryer's control panel assembly.
Steps to disassemble the dryer's cover cabinet.
Steps to disassemble the front section of the tub drum.
Procedure for removing the drum assembly from the dryer.
Instructions for replacing the drum lamp bulb.
Procedure for removing and replacing the dryer exhaust duct.
Steps to disassemble and remove the lint filter assembly.
Steps to disassemble the blower housing and its components.
Steps to disassemble the back cover of the dryer.
Steps to remove the air duct from the dryer.
Procedure for removing the drum rollers.
Exploded view diagram of the control panel and associated plate assembly.
Exploded view diagram of the cabinet and door assembly for gas dryer models.
Exploded view diagram of the drum and motor assembly for gas dryer models.
Exploded view diagram of the drum and motor assembly for electric dryer models.
To Next Page
General