Need help?Do you have a question about the Kenmore 796.8031.900 and is the answer not in the manual?
Emphasizes returning grounding devices to their original position after service.
Provides immediate actions to take if a gas leak is detected.
Guidelines to prevent damage to electronic components from static electricity.
Details the 4-wire, 3-wire, and optional 3-wire connection procedures for the power cord.
Instructions for connecting the gas supply pipe to gas dryer models.
Testing thermal cut-off, hi-limit, and outlet thermostats.
Testing door switch, idler switch, and lamp holder components.
Procedures for testing heater, thermistor, and motor components.
Testing procedures for gas valve, igniter, and frame detect.
Testing specific thermostats and cut-offs for gas dryer types.
Steps to activate the dryer's diagnostic test mode.
Procedure to check the 120V AC electrical supply to the dryer.
Measuring thermistor resistance with the power off.
Steps to test the dryer's motor and related components.
Procedure for testing the moisture sensor's continuity and resistance.
Testing the door switch for proper operation and resistance.
Testing the heater switch and related components for electric dryers.
Procedure to test the gas valve and related components for gas dryers.
Step-by-step guide to remove the top plate of the dryer.
Instructions for disassembling the control panel assembly.
Steps to disassemble the dryer's cover cabinet.
Procedures to disassemble the front tub drum and the drum assembly.
Instructions on how to replace the drum lamp bulb.
Guide for changing or replacing the dryer's exhaust duct.
Procedures for disassembling filter, blower housing, and back cover.
Steps to disassemble and remove the air duct and rollers.
Exploded view of the control panel and associated parts.
Exploded view of the cabinet and door assembly for gas models.
Exploded view of the drum and motor assembly for gas models.
Exploded view of the drum and motor assembly for electric models.
To Next Page
General