Need help?Do you have a question about the Kenmore 796.88852800 and is the answer not in the manual?
Disconnect power before servicing the product to avoid personal injury.
Ensure grounding wires, screws, straps, clips, nuts, or washers are returned to their original position.
Steps to follow if you smell gas, including not lighting matches or using phones.
Handle sensitive electronics carefully to prevent damage from static electricity.
Instructions for connecting 4-wire and 3-wire power cords to the dryer.
Guidance for connecting the gas supply pipe to a gas dryer, including natural and LP gas.
Procedures to test thermal cut-off and hi-limit/outlet thermostats for proper resistance.
Testing procedures for lamp holder, door switch, and idler switch resistance.
Testing resistance values for the heater, thermistor, and motor components.
Procedures for testing gas valve, igniter, and frame detect components.
Testing procedures for hi-limit thermostat (auto reset) and thermal cut-off (manual reset).
Instructions on how to activate the diagnostic test mode for the dryer.
Procedure to check 120V AC electrical supply and troubleshoot power issues.
Examines tab relay connections and status for electric and gas dryer models.
Procedure to measure thermistor resistance with power off to check functionality.
Tests motor functionality by measuring resistance and checking switch operations.
Evaluates moisture sensor performance by measuring resistance and voltage under different conditions.
Checks door switch operation by measuring resistance when the door is open or closed.
Tests the heater switch in electric dryers by measuring resistance and checking motor operation.
Tests the gas valve in gas dryers by checking voltage and terminal resistance.
Step-by-step guide to disassemble the dryer's control panel assembly.
Procedure to remove the dryer's top plate, requiring careful handling of edges.
Steps to disassemble the cover cabinet, including door removal and screw removal.
Guide to disassemble the front tub drum assembly, including lamp connector removal.
Instructions for drum assembly removal and replacing the drum lamp bulb.
Steps to remove and reconnect the dryer exhaust duct for maintenance or replacement.
Procedure to remove the dryer's filter assembly, including grill and sensor disconnection.
Steps to disassemble the blower housing, including fan, motor, and air guide removal.
Guide to remove the dryer's back cover, including drum and screw removal.
Instructions for removing the air duct and dryer rollers.
Diagram showing the exploded view of the control panel and plate assembly.
Diagram illustrating the exploded view of the dryer's cabinet and door assembly.
Diagram showing the exploded view of the drum and motor assembly for gas type dryers.
To Next Page
General