Kenmore 970-7030 Series User Manual

26
Changing the Filter
Locating the Filters
Your refrigerator is equipped with water
ltering system. The water lter system
lters all dispensed drinking water, as well
as the water used to produce ice.
Water Filter
The water lter is located at the top right
side of the fresh food compartment.
Ordering Replacement Filters
To order your replacement lters, please
visit the dealer where you purchased your
refrigerator. Sears recommends that you
order extra lters when you rst install
your refrigerator, and that you replace
your lters at least once every six months.
Here is the product number to request
when ordering:
Kenmorepure!
TM
Water Filter
Part #9919
Replacing the Water Filter
In general, you should change the water
lter every six months to ensure the highest
possible water quality. Water Filter Status
on the user interface prompts you to replace
the lter after a standard amount of water
(200 gallons/757 liters for Kenmorepure!
TM
)
has owed through the system.
If your refrigerator has not been used
for a period of time (during moving
for example), change the lter before
reinstalling the refrigerator.
Filter Cartridge
Do not use with water that is
microbiologically unsafe or of unknown
quality without adequate disinfection
before or after the system. Systems
certied for cyst reduction may be used
on disinfected waters that may contain
lterable cysts.
Test & Certication Results:
• Rated Capacity - 200 gallons/757 liters
for Kenmorepure!
TM
ice and water lter
• Rated service ow - .50 gallons per minute
• Operating Temp.: Min. 33°F, Max. 100°F
• Maximum Rated Pressure - 100 pounds
per square inch
• Recommended Minimum Operating
Pressure: 30 pounds per square inch
To Replace your Kenmorepure!
TM
Water Filter:
It is not necessary to turn the water supply
o to change the lter. Be ready to wipe
up any small amounts of water released
during the lter replacement.
1. Turn O the ice maker power switch.
2. Remove the lter by pushing on the
end/face of the lter.
3. Slide the old water lter cartridge
straight out of the housing and
discard it.
4. Unpackage the new lter cartridge.
Using the alignment guide, slide it
gently into the lter housing until it
stops against the snap-in connector
at the back of the housing.
5. Push rmly until the cartridge snaps
into place (you should hear a click
as the cartridge engages the snap-in
connector).
The Kenmorepure!
TM
ice and
water lter system is tested
and certied to NSF/ANSI
Standards 42 and 53 for the
reduction of claims specied on
the performance data sheet.
More about your Advanced Water Filter
NOTE
When ordering your replacement lter,
please reorder the same lter type that
is currently in your refrigerator.

Kenmore 970-7030 Series Specifications

General

Brand	Kenmore
Model	970-7030 Series
Category	Freezer
Language	English