11
Status Indicator Lights
The console lights provide information about
the cycle selection and current status. During
operation, while the door is closed, these lights
will remain off and will automatically turn on
when the door is opened. At the completion
of a cycle, the clean light will come on. The
sanitization light will also come on if that
option was selected and sanitization was
achieved during the wash cycle.
Operating Instructions
Delay Start
The DELAY START option allows you to
automatically delay starting your dishwasher
1-24 hours.
To start the DELAY START option, press DELAY
START until the desired delay time shows in the
STATUS window. A light will come on indicating
the delay has been set and will remain on until
cycle starts.
To cancel the DELAY START option and to begin
the selected cycle before the delay period is
over, press START/CANCEL twice.
Child Lock Controls
To prevent children from accidently changing
To prevent children from accidently changing
the dishwasher cycle or starting the dishwasher,
the dishwasher cycle or starting the dishwasher,
lock the dishwasher controls by press and
lock the dishwasher controls by press and
hold the DELAY START for 3 seconds. An
hold the DELAY START for 3 seconds. An
indicator light on the lock graphic pad will
indicator light on the lock graphic pad will
illuminate when the controls are locked and no
illuminate when the controls are locked and no
new selections can be made until the lock is
new selections can be made until the lock is
released. To unlock the controls, press DELAY
released. To unlock the controls, press DELAY
START again for 3 seconds, and the indicator
START again for 3 seconds, and the indicator
light will go out.
In the unlikely event that the dishwasher
malfunctions, displays the error code
“Uo”, or gives poor performance you can
call the Kenmore Customer Care Center at
1-800-4MY-HOME. They will be able to
provide assistance in troubleshooting the
problem and/or locating an authorized
service technician, if needed.
To Cancel a Cycle
You can cancel a cycle anytime during the
cycle. Press START/CANCEL pad and the
dishwasher will start a 90 second drain. At the
end of the drain, select the desired cycle.
Minutes................. Number of minutes
left in cycle (1-199).
PF............................ Appears in window
when dishwasher is fi rst
connected to power or
when power is restored
following an interruption.
To clear, select START/
CANCEL or close door.
Status Window
CD.......................... Close dishwasher door.
The status indicator
lights will also fl ash to
indicate current cycle
status.
1H-24H.................. Number of delay start
hours. The last hour will
count down in minutes.
The STATUS window, available on some
models, indicates the following activity:
To Next Page
Loading...