EasyManua.ls Logo

Kenmore 970L4802 - Start the Washer

Kenmore 970L4802
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Operating instructions
Operating Your Washer, continued
° To select or delete an option, pressOptions; then,
while the indicator is blinking, press Select. The indi-
cator will light when the option has been selected. It
will no longer be lighted when the option has been
deleted.
NOTE
To provide the best care for your laundry, not every
setting or option is available with every cycle. If a
setting or option is not available for the cycle selected,
° Adjustments to a cycle will be remembered and re-
called each time that cycle is selected in the future.
* To return to factory settings, press the START/PAUSE
and Select buttons at the same time and hold until
the signal sounds.
@ Hot Extra High
G Warm Q High
O Cool Q Medium C) DOORLOCK
Q Cold () Low O SENSING
WASH
Cold Clean No Spin TOUCHPAUSE
TOADDA GARsV,_NT
O elay
Start
Q Chime
Stain Treat G Heavy
0 Extended Spin 0 Normal
Extra Rinse Light
Auto Spin Options _ Soll
Temp Speed j Level
Press and hold both for ten seconds
to return to factory settings.
7 Start the washer.
° Close the door and press START. The washer will not
operate with the door open. "PF1U" will be displayed
as a reminder to close the door.
° Select Delay Start to delay the beginning of the
cycle, if desired.
° As a safety measure, the door will automatically loci<
during the entire wash cycle and the Door Loci< indi-
cator will be lighted.
° "TOUCH PAUSE TO ADD A GARMENT"
To add a forgotten item to the wash drum, press
PAUSE and open the door. "PF_U" will be displayed
alternately with the estimated remaining cycle time.
Add the item, close the door and press Start to re-
sume the cycle.
* If changes to the settings or options are attempted
after the cycle starts, you will hear several beeps
when the buttons are pressed. To change the settings
or options, press PAUSE, make the new selections and
press START again.
° To change the cycle once the cycle has begun, press
Cancel, select a new cycle, and press START again.
Just turning the cycle selector knob will not change
the cycle.
* To stop the cycle, press CANCFL
N, .............................................................................................................................................................................
If the cycle is interrupted during spin, it iil take
approximately 2-3 minutes for the door lock to release.
DO NOT force open the door.
* A signalwillsound at the end of the cycle if the
Chime option has been selected.
° Remove items from the washer when the cycle ends
and place in dryer, line dry or dry fiat as directed on
the fabric care label.
For best results
Follow the fabric care label instructions
on items to be washed.
* Excess wrinkling,color transfer or odors may develop
in items left in the washer after the cycle has ended,
if not removed promptly.
CAUTION
Do not leave the door open if there are small children or
pets present. An open door could entice children to hang
on the door or crawl inside the washer. If there are no
small children present, you may leave the door ajar to
13

Related product manuals