11
ENGLISH
Setting Surface Controls
Fig. 2 Fig. 3
Fig. 4 Fig. 5
1. Touch
O
N/
O
FF
pad at the Warmer Zone control position. The Warmer Zone indicator light
located above the ON/OFF pad will flash. Note: If no further pads are touched within 25
seconds the request to power the Warmer Zone ON will clear.
2. At the Warmer Zone controls position touch once to turn ON the power level for HI
(Fig. 2) or to turn ON the power level for LO (Fig. 5). The Warmer Zone Indicator light
will turn on steady and the Hot Surface indicator light will turn ON when the Warmer Zone
becomes hot (Figs 2).
3. Each touch or will increase or decrease the power levels. The Warmer Zone
has 5 power levels from HI (Fig. 2) through MED (Fig. 4) to LO (Fig. 5). The power level may
be adjusted at any time while the Warmer Zone is ON.
4. When it is time to serve the food, touch
ON/OFF
pad once to turn the Warmer Zone OFF. The
Warmer Zone indicator light will turn OFF.
Note: The Surface indicator light will remain ON if the cooktop is still hot and will remain ON
until the heating surface area has cooled sufficiently (Fig. 3).
Radiant surface elements may appear to have cooled after they have been turned
off. The glass surface may still be hot and burns may occur if the glass surface is touched
before it has cooled sufficiently.
Do not place aluminum foil or plastic items such as salt and pepper shakers, spoon holders or plastic
wrappings on top of the range when it is in use. These items could melt or ignite. Potholders, towels or wooden spoons
could catch fire if placed too close to the surface elements or burners.
The Warmer Zone will not glow red when it is hot, but becomes hot enough to cause burns. Avoid placing hands
on or near the Warmer Zone until the Warmer Zone Hot Surface indicator light is OFF. Always use potholders or oven mitts
when removing food from the warmer zone as cookware and plates will be hot.
Operating the Warmer (Warm & Ready™) Zone
The purpose of the Warmer Zone is to keep hot cooked foods at serving
temperature. Use the Warmer Zone to keep cooked foods hot such as:
vegetables, gravies, casseroles, soups, stews, breads, pastries and oven-
safe dinner plates. Always start with hot food. It is not recommended to heat
cold food on the Warmer Zone.
All food placed on the warmer zone should be covered with a lid to maintain
quality. For best results, when warming pastries or breads, the cover should
have an opening to allow moisture to escape. Do not use plastic wrap or
aluminum foil to cover food. Plastic or aluminum may melt onto the
surface.
Use only plates, utensils and cookware recommended for oven and cooktop
use on the Warmer Zone.
Warmer Zone Temperature Selection
Refer to the Warmer Zone table for recommended heating levels (Fig. 1). If
a particular food is not listed, start with the medium level, and adjust as
needed. Most foods can be kept at serving temperatures by using the
medium level.
To Set the Warmer Zone Control:
Fig. 1
Warmer Zone Recommended Food
Settings Table
Food Item Heating Level
Hot Beverages HI
Fried Foods HI
Vegetables MED
Soups (Cream) MED
Stews MED
Sauces MED
Meats MED
Gravies LO
Eggs LO
Dinner Plates with Food LO
Casseroles LO
Breads/Pasteries LO
ON/OFF
WARMER
ZONE
RÉCHAUD
HI
MED
LO
ON/OFF
WARMER
ZONE
RÉCHAUD
HI
MED
LO
To Next Page
Loading...
Need help?
General