32
Care & Cleaning
Do not use the following on the cooktop:
• Do not use abrasive cleaners and scouring pads, such as
metal and some nylon pads. They may scratch the cooktop,
making it more diffi cult to clean.
• Do not use harsh cleaners, such as chlorine bleach, ammonia
or oven cleaners, as they may etch or discolor the cooktop.
• Do not use dirty sponges, cloths or paper towels, as they can
leave soil or lint on the cooktop which can burn and cause
discoloration.
Cooktop Cleaning (cont’d)
Special Caution for Aluminum Foil and Aluminum
Cooking Utensils
NEVER cover any slots, holes or passages
in the oven bottom or cover an entire rack with materials
such as aluminum foil. Aluminum foil linings may trap
heat, causing a fi re hazard.
Protective Liners — DO NOT USE
ALUMINUM FOIL to line the oven bottom. Since the melting
point of aluminum is much lower than that of other metals,
the aluminum may melt and permanently merge with the
porcelain.
• Aluminum foil: Use of aluminum foil will damage the
cooktop. Do not use under any circumstances.
• Aluminum utensils: Since the melting point of aluminum is
much lower than that of other metals, care must be taken
when aluminum pots or pans are used. Pans that boil dry
may permanently damage cooktop by breaking, fusing to,
or marking it.
Halogen
Light Bulb
Lift up and pull out.
Replacing the Halogen Oven Light
The oven lights will automatically turn ON when the oven
door is opened. The oven lights may also be manually
operated by pressing the
pad.
The oven light bulb is covered with a glass shield. The
glass shield can be removed to be cleaned manually or to
change oven light. THIS GLASS SHIELD MUST BE IN PLACE
WHENEVER THE OVEN IS IN USE.
To replace the light bulb:
BE SURE THE OVEN IS COOL.
1. Turn the power off at the main source.
2. Wear a leather-faced glove for protection against
possible broken glass.
3. To remove the glass shield, lift up on side and use force
to pull shield out.
4. Replace halogen light appliance bulb taking care not
to touch the bulb with your bare fi ngers. Touching bulb
with your skin can leave a fi lm on the bulb that causes
it to burn out quickly.
5. Replace glass shield in opposite order and manner of
removal.
To Next Page
Loading...
Need help?
General
