HEPA MEDIA EXHAUST FILTER
EXHAUST FILTER
The exhaust filter must be replaced when
it becomes dirty. The timing between
replacement intervals will depend on the
use conditions the vacuum cleaner is
exposed to. The filter should be checked
when emptying the dust cup. The filter
CANNOT be washed as it will lose its
dust trapping ability.
1. Remove exhaust filter cover by pulling
the release tab on the cover and rotating
out from vacuum cleaner.
2. Remove the
HEPA Media
exhaust filter
from vacuum
cleaner.
3. Place new
filter cartridge
into vacuum
cleaner as
shown.
4. Replace the exhaust filter cover by
placing bottom tab into the slot.
5. Rotate filter cover onto vacuum
cleaner, and press down as shown, until
cover snaps into place.
To Next Page
Loading...
Need help?
General
