To Next Page

To Previous Page

Fig. 1

Fig. 2

Fig. 3

Fig. 4

Fig. 5

Setting the Clock

The pad is used to set the clock. The clock may be set for 12 or 24 hour time of day operation. The clock has been preset

atthefactoryforthe12houroperation.Whentherangeisrstpluggedin,orwhenthepowersupplytotherangehasbeen

interrupted,thetimerinthedisplaywillash.

Press

.Thedisplaywillstopashing.

To set the clock (example below for 1:30)

1. Press . "CLO" will appear in the display (Fig. 1).

2. Press 1 3 0 pads to set the time of day to 1:30 (Fig. 2). Press .

The time of day will appear in the display (Fig. 3).

Changing between 12 or 24 hour time of day display

1. Press and hold for 7 seconds until "12Hr" or "24Hr" appears in

the display.

2. Press

to switch between the 12 and 24 hour time of day display.

The display will show either "12Hr" (Fig. 4) or "24Hr" (Fig. 5).

3. Press

to accept the change or press to reject the

change.

4. Reset the correct time as described in To set the Clock above. Please

note that if the 24 hour time of day mode was chosen, the clock will

now display time from 0:00 through 23:59 hours.

1 3 0

for 7 seconds

or press

INSTRUCTIONS PRESS DISPLAY

Kenmore Elite 318205329A User Manual

Questions and Answers: