21
Reversing Door Swing
Reversing the hinge
ROUND PLUG
ROUND PLUG
SQUARE PLUG
HINGE SCREWS
OUT
IN
1. Carefully pull out the 2 small round hole plugs from the
front panel and save. Remove and save the square “T”
slot cover by sliding it up and pulling it out. Move all 3
plugs to the opposite side of the front panel and insert.
2. Turn inner door assembly over to expose retaining tabs
of metal strike. Grip tabs fully with pliers to remove.
Discard old metal strike.
4. From the back side of the inner door, pinch the
retaining tabs of the plastic square plug to release it.
Save square plug for reinstallation.
5. Carefully remove the 2 round plugs from the inner door
and move them to the opposite holes and reinstall.
6. Rotate the hinge and move it to the opposite side of
the inner door. Attach it with the 2 pan head screws
removed previously. Reinstall plastic plug in the square
hole next to the hinge.
3. Turn the inner door assembly back over and locate
the 2 pan head hinge screws. Remove and save the
2 screws and separate the hinge from inner door
assembly.
To Next Page
Loading...
Need help?
General