Threading the Lower Looper
©©
Open the looper and side covers.
Snap off presser foot.
Place the spool of thread on the right side soool pin.
I - Points to thread for lower Ioooer are marked
10 in green.
_J
Thread guide
\\
'x
1_ Draw the thread through
the right side thread guide
from back to front,
Thread guide
31ate
(_) Pass the thread througn
holes on the right side of
thread guide plate as illu-
strated,
Looper thread guide
\
(_ Pass the thread through the
right side of thread guide
sliding the thread from left
to right.
How to Thread Only the Lower Looper
Cut both needle threads as shown in the figure ana remove
them from the needles.
Thread the lower looper and then re-thread the needles.
To Next Page
Loading...
Need help?
General
