8. By pressing key [ ] enter command ‘Switch on the decoder‘ in the
memory. By pressing key [2] enter command ‘Go to channel 2 of the
decoder‘ in the memory. After pressing each key the light indicator will
ash once.
9. By pressing key [DVB-T] exit the setup mode. The indicator will go out
and setting will be completed.
Notes:
- You can choose another device (SAT, DVD) instead of the TV or DVB-T.
When you want to use the macro command, point the remote towards
the controllable devices and press key [M1]. Control commands will be
transmitted to the devices in the sequence that they were previously
programmed.
Deleting of macro commands from memory
1. In the setup mode of macro commands (see the section ’Adding of
macro command’ 1st, 2nd and 3rd paragraph), press the key [M1] once,
the command will be deleted from the accordant memory. When the
multifunction command will be deleted, light indicator will ash three
times.
2. In order to completely delete the data of the macro command, in the
setup mode of macro command press and hold the key [M1] until the light
indicator ashes three times. Press any other key to exit the deletion mode.
Resetting of factory settings
Simultaneously press and hold keys [VOL+] and [PROG ] until indicator
switches on. Release both keys.
In order to reset factory settings, enter code 9990. All programmed codes
and their indication data, content of learning function, memory of favorite
channels (FAV) and multifunction (M1) will be completely deleted.
- 10 -
3301053
To Next Page
