Press keys [VOL+] and [PROG ]
simultaneously and release them
only when the indicator switches
on and remains lit.
Enter a 4-digit code (e.g. for TV
‘PHILIPS‘ the code is ‘1492’).
If the code is entered correctly, the
light indicator will ash twice and
then go out. If the code is entered
incorrectly (any digit of the code is
entered incorrectly), the indicator
will ash three times and remain
in the setup mode (the light
indicator is on). Enter the code
again. After successful setup the
indicator should go out.
Press the key indicating the device
to complete setup of the remote
(in this case [TV]).
If you wish to program the remote for more devices, press the key of the
selected device ( SAT, DVD or DVB-T) at the beginning of setup procedure
(clause A.1) and continue the same way.
If the remote RC-949 is used for several devices, press the appropriate
key on the remote and the remote will switch over to the signal of the
corresponding device. E.g. if you want to operate TV decoder, press
[DVB-T], if you later on wish to operate for television, switch the remote
to TV pressing [TV].
Indicator o
IMPORTANT: Write down the
correct code for each device in
the code table at the end of the
manual after code list. Thus you
will be able to nd it fast and
easy, if necessary.
Point the remote towards the
controllable device and check
that the keys of the remote are
working. If some or all of the main
keys are not working, repeat steps
2 - 6 and try other codes from the
list until all main keys are working
properly.
- 5 -
3301053
To Next Page
Loading...
