Manually switch on the
controllable device (e.g. TV)
It must be fully switched on, not
just in standby mode! For a DVD
device – insert a DVD disc, and
switch the playback mode on.
For an SAT – select any program.
A picture of the selected device
should appear on the screen.
Press the key of the controllable
device on the remote (e.g. for the
television – [TV]). A light indicator
will switch on. Release the key.
The indicating light is on
In the table of device codes (‘SET-
UP CODES FOR...‘), nd the brand
and corresponding digital code of
the device to be operated.
Device codes:
TV - television (codes: 1000-1981)
SAT - satellite receiver
(codes: 3000-3773)
DVD - DVD player
(codes: 4000-4285)
DVB-T - decoder
(codes: 5000-5053)
IMPORTANT: the codes have been listed according to the demand for each
brand’s devices. It means that the rst codes are the most common ones,
therefore start code setup in sequence from the top of the list starting with
the rst, second, third code etc. Don’t start code setup from the middle or
the end of the list.
A. CODE SETUP FROM THE CODE TABLE MANUAL METHOD
‘Code setup from the code table’ is a very precise method and ensures
optimum result; therefore we recommend starting setup of the remote
using this method. Open the code table at the end of the manual to begin
setup with ‘Code setup from the code table’. The code table can be found
also in webpage: digotv.eu
- 4 -
3301053
To Next Page
Loading...
