Kenner RC-949 - Page 8

In order to ’teach’ other keys, repeat the same teaching procedure with
other keys. When all keys have been ’taught’, press EXIT key to exit the
learning mode.
Note:
If the memory of data to be copied is full, the indicator will slowly ash
for eight times to warn the user that there is no free space in the memory.
Note:
1. Each key of this remote (except for keys denoting type of device [TV],
[SAT], [DVD], [DVB-T] and [FAV], [M1]) can be ’taught’. In total, 114 keys
Point the emitting end of the
teaching (original) remote
towards the receiving window of
the RC-949 (in the distance of 3-5
cm).
Press one key of the teaching
(original) remote (accordant
command will be transmitted)
until the indicator of the remote
RC-949 switches on and begins
to ash. It will show that the
transmitted signal has been
received. Release the key.
Press the key of the RC-949 in
the memory of which you will
record the received command.
The indicator will begin to ash
again and then will remain lit; it
will show that the command has
been recorded in the memory of
the accordant key.
Enter code 9998. The indicator
will go and then switch on
again. The learning mode is now
switched on.
- 8 -
3301053