Kentucky Junior - Page 40

40
4-H Apparel and Textiles—Sewing
18 U. S. C. 707
4JD-01PB
University of Kentucky - Cooperative Extension Service - College of Agriculture
Sewing Instructions:
Interfacing
Apply interfacing to wrong sides of each end
of bag, ap, straps, and handle pieces.
Apply Trim to Outer Fabric
1. Along one long side of the flap trim
pieces (I & J), turn edge under  inch;
press.
2. Lay the two long pieces (I) with raw
edges even with sides of the flap front,
right sides facing up. Topstitch close to
the pressed-under edge.
3. Repeat with trim
piece J, matching
raw edge to low-
er edge of flap
and top stitch in
place. (Figure D).
4. On bottom trim
pieces (F), turn
under ¼ inch along both long edges;
press.
e. f. f.
1 sq yard
Lining/trim
e. bag (1 pc) ..........................................29” x 14”
f. bottom trim (2 pcs)...................... 14” x 3½”
g. pocket lining (1 pc)...................... 15½” x 7”
h. ap lining (1 pc) ............................... 9¼” x 7”
i. ap trim (2 pcs) ................................9¼” x 2”
j. ap trim (1 pc) ......................................7” x 2”
k. straps (2 pcs) .................................. 3½” x 33”
l. ap (1 pc) ...........................................9¼” x 7”
m. top edges (2 pcs).......................... 2½” x 14”
n. handle (1 pc) .................................. 3½” x 12”
g.
h.
i. i. j.
d.
a. straps (2 pcs) .................................. 33” x 3½”
b. bag (1 pc) ..........................................29” x 14”
c. ap (1 pc) ...........................................9¼” x 7”
d. handle (1 pc).................................. 12” x 3½”
1 sq yard
Outer fabric
a. a. b. c.
1 sq yard
Interfacing fabric
k. k. l.
m. m.
n.
Cutting Instructions:
From outside fabric: (Figure A)
a. Straps (2) 33-inch x 3-inch
b. Bag (1) 29 inches x 14 inches
c. Flap (1) 9¼ inches x 7-inches
d. Handle (1) 12-inch x 3  -inch
From lining/trim: (Figure B)
e. Bag lining (1) 29-inch x 14-inch
f. Bottom trim (2) 3-inch x 14-inch
g. Pocket lining (1) 7-inch x 15-inch
h. Flap lining (1) 9¼-inch x 7-inch
i. Flap trim (2) 2-inch x 9-inch,
j. Flap trim (1) 2-inch x 7-inch
From interfacing: (Figure C)
k. Straps (2) 33” x 3 ”
l. Flap (1) 9 ” x 7
m. Top edges (2) 2 ” x 14”
n. Handle (1) 12” x 3 ”
h.i. i.
raw edge
nished edge
j.
Figure CFigure BFigure A
Figure D.