Need help?Do you have a question about the Kenwood AT-200 and is the answer not in the manual?
Explains the meter's function for reading SWR and transmit power on different scales.
Describes how to select the wattmeter's full scale for 20W or 200W.
Explains how to use the switch to read forward or reflected power.
Details the switch that selects between wattmeter and SWR meter functions.
Describes the CAL switch used for SWR measurement calibration.
Explains the CAL control used to calibrate the SWR meter.
Details the antenna switch for selecting antennas or a dummy load.
Explains setting the band switch for the desired operating frequency range.
Describes the R TUNE control for adjusting the resistance component.
To Next Page
General
