Kenwood Basic M1 - Page 2

Dear audio fan
The
purpose
of
this
manual
is
to
acquaint
you
with
the
operating
features
of
your
new
amplifier.
You
‘will
notice
that
in
every
detail
of
planning,
engineering,
styling,
operating
convenience,
and
adap-
tability, we
have
sought
to
anticipate
your
needs
and
desires.
We
suggest
that
you
read
this
manual
carefully.
Knowing
how
to
set
up
your
amplifier
to
the
best
advantage
will
enhance
your
listening
pleasure
right
from
the
start.
You
will
also
become
aware
of
the
ease
with
which
you
can
adjust
your
amplifier
to
meet
your
special
requirements.
Contents
Before Operation 200 ce ccc ccccececeeeceseceueees 3
SySteEM CONNECTIONS .20...eccecec ccc ec cae eveeseeecs 4
Controls, indicators and connectors ....................... 6
In case of difficulty... 0.0. eecccces eve eeeceeeeee 6
Block diagram 200.20... ce ccc ecccececeeeeeneneneeeaes 7
Specifications ooo eee cc ec eee eeceeceveeeeeees 7
For your records
Record the serial number, found on the back of the unit,
in the spaces designated on the warranty card, and in
the space provided below. Refer to the model and serial
numbers whenever you call upon your Kenwood dealer
for information or service on this product.
Model BASIC M1 Serial number
Unpacking
Unpack the unit carefully and make sure that all ac-
cessories and cables are put aside so they will not be
lost. Examine the unit for any possibility of shipping
damage. If your unit is damaged or fails to operate,
notify your dealer immediately. If your unit was shipped
to you directly, notify the shipping company without
delay. Only the consignee (the person or company
receiving the unit) can file a claim against the carrier for
shipping damage. We recommend that you retain the
original carton and packing materials for use should
you transport or ship the unit in the future.
WARNING:
TO
PREVENT
FIRE
OR
SHOCK
HAZARD,
DO
NOT
EXPOSE
THIS
APPLIANCE
TO
RAIN
OR
MOISTURE.
IMPORTANT!
U.S.A. and Canada
Units shipped to the U.S.A. and Canada are
designed for operation on 120 volts AC only.
These units are not equipped with AC Voltage
Selector switch and the discussion of such a
switch that follows should be disregarded.
All other countries
Units shipped to countries other than the U.S.A.
and Canada are equipped with an AC Voltage
Selector switch on the rear panel.
Refer to the following paragraph for the proper
setting of this switch.
AC voltage selection
This unit operates on 120 volts or 220 volts AC.The
AC Voltage Selector Switch on the rear panel is set to
the voltage that prevails in the area to which the unit is
shipped. Before connecting the power cord to your AC
outlet, make sure that the setting position of this switch
matches your line voltage. If not, it must be set to your
voltage in accordance with the following direction.
Note:
Our warranty does not cover damage caused by excessive line
voltage due to improper setting of the AC Voltage Selector Switch.
120V~ <« » 220V~ 120V\ 4 »220V~
Switch lever
o=e
This shows switch
lever is locked in
220V~position.
This shows switch
lever is locked in
120V~position.
Move switch lever to match your
line voltage with a small screw
driver or other pointed tool.
AC voltage selector switch