Kenwood Basic M1 - Kenwood BASIC M1 Current Source Overview; Understanding the Current Source

Before operation
Notes on installation
Do not place the unit in a place which is exposed to
direct sunlight, near a heating appliance, etc.
Do
not
place
a
vase
containing
water,
makeup,
etc.
on
the
unit.
Do
not
use
in
a humid
place.
Cn
To maintain good ventilation, do not put records or a
table-cloth on the unit. Place the unit at least 10 cm
away from the walls.
Choose a location that is relatively free from vibration or
excessive dust.
Safety precautions
Never remove the case. If the internal parts are touched,
accidently, a serious electric shock might occur.
Never touch internal
parts
lf a metal object, such as a hair pin or a needle, comes
into contact with the power socket on the rear panel, a
dangerous electric shock may result. For families with
children, never permit children to put anything,
especially metal, inside this unit,
Do
not
connect
other
audio
equipment
with
a
power
consumption
larger
than
that
specified
to
the
AC
outlet
on
the
rear
panel.
Never
connect
other
electrical
appliances,
such
as
an
iron
or
toaster.
¢ ) Never connect:other
+
electrical appliances
Touching
the
power
plug
when
your
hands
are
wet
may
result
in
a
serious
electric
shock.
C Never touch with wet
W hands
Never pull, bend or extend the power cord. This could
damage the power cord, resulting in a broken cord or
short-circuit.
~~
» Always grasp the plug.
7
in case of abnormal smell
\f an abnormal smell or smoke is detected, immediately
turn the power OFF and pull out the power cord. Contact
your dealer or nearest Kenwood Service Station.
Thermal protector
This unit employs a thermal protector which
automatically shuts off the power if the temperature in-
side the amplifier becomes unusually high. The protector
automatically restores the power when the temperature
drops to the normal level and the cause of the unusual
temperature rise must be removed before the power Is
restored. Unusually high temperatures may be caused
by continuous driving of low-impedance speaker
systems at high power or shorted output circuit.
Cleaning
Do not use volatile solvents such as alcohol, paint thin-
ner, gasoline, benzine, etc. to clean the cabinet. Use a
silicone cloth or a clean dry cloth.
C
Sibcome
Cloth
Silicone cloth Thinner Benzine