Need help?Do you have a question about the Kenwood DCK-1 and is the answer not in the manual?
Details the signal path and main components of the R-1000 receiver.
Explains the Phase Locked Loop circuit configuration and its role in frequency synthesis.
Describes the operation of the counter and clock functions, including the MSM5524 IC.
Details the pin functions, operating modes, and time correction features of the MSM5524 IC.
Identifies and labels all controls and connectors on the front of the receiver.
Identifies and labels all connectors and ports on the rear of the receiver.
Shows the layout of internal components as viewed from the top.
Shows the layout of internal components as viewed from the bottom.
Provides the schematic diagram for the PLL unit.
Provides the schematic diagram for the RX unit.
Provides the schematic diagram for the VFO unit.
Details resistor and capacitor types, values, and tolerances.
Lists general housing, panel, and accessory parts.
Lists transistors and ICs used in the receiver.
Lists inductors, crystals, and trimmer capacitors.
Lists parts specific to VFO, RX, and other units.
Lists switches, potentiometers, and trimmer components.
Shows how to disassemble the unit case and lists associated hardware.
Details the disassembly process for the front panel and RX unit.
Provides instructions for packing the unit for shipment, including component bags.
Guides users through troubleshooting power supply and audio output problems.
Addresses issues related to RF reception, IF stages, and PLL circuit problems.
Lists required test equipment and initial setup steps before adjustments.
Details adjustments for power supply, RB line, and BFO circuits.
Covers alignment steps for VFO, clock, RF/IF stages, and MCF circuits.
Guides on PLL tuning, bandpass filters, and S-meter calibration.
Illustrates alignment points on the RX, PLL, and VFO units.
Lists the technical specifications and parts for the SP-100 speaker accessory.
Details the signal path and main components of the R-1000 receiver.
Explains the Phase Locked Loop circuit configuration and its role in frequency synthesis.
Describes the operation of the counter and clock functions, including the MSM5524 IC.
Details the pin functions, operating modes, and time correction features of the MSM5524 IC.
Identifies and labels all controls and connectors on the front of the receiver.
Identifies and labels all connectors and ports on the rear of the receiver.
Shows the layout of internal components as viewed from the top.
Shows the layout of internal components as viewed from the bottom.
Provides the schematic diagram for the PLL unit.
Provides the schematic diagram for the RX unit.
Provides the schematic diagram for the VFO unit.
Details resistor and capacitor types, values, and tolerances.
Lists general housing, panel, and accessory parts.
Lists transistors and ICs used in the receiver.
Lists inductors, crystals, and trimmer capacitors.
Lists parts specific to VFO, RX, and other units.
Lists switches, potentiometers, and trimmer components.
Shows how to disassemble the unit case and lists associated hardware.
Details the disassembly process for the front panel and RX unit.
Provides instructions for packing the unit for shipment, including component bags.
Guides users through troubleshooting power supply and audio output problems.
Addresses issues related to RF reception, IF stages, and PLL circuit problems.
Lists required test equipment and initial setup steps before adjustments.
Details adjustments for power supply, RB line, and BFO circuits.
Covers alignment steps for VFO, clock, RF/IF stages, and MCF circuits.
Guides on PLL tuning, bandpass filters, and S-meter calibration.
Illustrates alignment points on the RX, PLL, and VFO units.
Lists the technical specifications and parts for the SP-100 speaker accessory.
To Next Page
General
