Why is the Kenwood GPS radio reception so poor?
Poor radio reception on your Kenwood GPS can occur if the car antenna is not fully extended. Ensure the antenna is pulled out completely. Also, check that the antenna control wire is correctly connected.
What to do if I cannot set up the equalizer on my Kenwood DNX4280BT?
If you cannot set up the equalizer on your Kenwood GPS, it might be because the dual zone function is enabled. Turn the dual zone function off.
What to do if I cannot select the output destination of the subsource in the dual zone on my Kenwood DNX4280BT?
If you cannot select the output destination of the subsource in the dual zone on your Kenwood GPS, it is probably because the dual zone function is disabled. Set the dual zone function to on.
Why I cannot adjust the volume of the rear speakers on my Kenwood GPS?
If you are unable to adjust the volume of the rear speakers on your Kenwood GPS, the dual zone function might be disabled. Enable the dual zone function.
What to do if there is no output from the subwoofer of my Kenwood GPS?
If there's no output from the subwoofer on your Kenwood GPS, the subwoofer might not be enabled. Ensure the subwoofer is set to 'on'.
General| Resolution | 800 x 480 pixels |
|---|---|
| Touchscreen | Yes |
| Navigation | Yes |
| Bluetooth | Yes |
| USB Ports | 1 |
| Audio Formats Supported | MP3, WMA, AAC, WAV |
| DVD Player | Yes |
| SD Card Slot | Yes |
| AUX Input | Yes |
| CD Playback | Yes |
| AM/FM Tuner | Yes |
| Voice Control | Yes |
| Steering Wheel Control | Yes |
| iPod/iPhone Control | Yes |
| HD Radio | No |
| Rear View Camera Input | Yes |
| Video Formats Supported | MPEG-1, MPEG-2 |
| Satellite Radio | Yes |
To Next Page
