Kenwood DP-R895 User Manual

Before operation
Disc handling precautions
Cleaning
If fingerprints or foreign matter be¬
come attached to the disc, lightly
wipe the disc with a soft cotton cloth
(or similar) from the center of the disc
outwards in a radial manner,
Do not attach paper or tape to either the
playing side or the label side of compact
discs.
Caution on disc used
Storage
When a disc is not to be played fora
long period of time, remove it from
the CD player and store it in its case.
Never play a cracked or warped disc.
During playback, the disc rotates at high speed in the player.
Therefore, to avoid danger, never use a cracked or deformed disc
or a disc repaired with tape or adhesive agent.
Discs which can be played with this unit
CD (12 cm, 8 cm), CDV (only the audio part)
• With CD-G tCD Graphics) discs, this unit can play only the audio.
Note related to transportation and movement
Before transporting or moving this unit, carry out the following
operations,
1. Turn the power ON but do not load a disc.
2. Wait a few seconds and verify that the display shown appears. Wait
further a few seconds,
3. Turn the power OFF.
o cf / 5 r 'B
13
17 IS ia ao
Beware of condensation
When water vapor comes into contact with the surface of cold
material, water drops are produced.
If condensation occurs, correct operation may not be possible, or the
unit may not function correctly.
This is not a malfunction, however, and the unit should be dried.
(To do this, turn the POWER switch ON and leave the unit as it is for
several hours.)
Be specially careful in the following conditions.
• When the unit is brought from a cold place to a warm place, and
there is a large temperature difference.
• When a heater starts operating.
• When the unit is brought from an air-conditioned place to a place of
high temperature with high humidity,
• When there is a large difference between the internal temperature
of the unit and ambient temperature, or in conditions where
condensation occurs easily.
DP-R89&t£n) 3

Kenwood DP-R895 Specifications

Audio Specifications

dynamic range	More than 94 dB
total harmonic distortion + noise	Less than 0.007 % (at 1 kHz)
number of channels	2 channels
channel separation	More than 90 dB (at 1 kHz)
playing rotation	200 rpm - 500 rpm
frequency response	4 Hz-20 kHz, ±1.0 dB
signal to noise ratio	More than 96 dB

Power and Conversion

output level/impedance	2.0 V/3.3 kΩ
D/A conversion	Bit Oversampling 8 fs (352.8 kHz)
power consumption	low

Weight and Dimensions

width	440 mm
height	128 mm
depth	392 mm
weight	5.0 kg