Need help?Do you have a question about the Kenwood eXcelon KFC-XW1100DVC and is the answer not in the manual?
General| Size | 10 inches |
|---|---|
| Power Handling (RMS) | 300 watts |
| Impedance | 4 Ohms |
| Mounting Depth | 5-1/8 inch |
| Mounting Hole Diameter | 9-1/8 inches |
| Type | Dual Voice Coil Subwoofer |
| Voice Coil | Dual 2-inch |
Warning about disposing of polyethylene bags to prevent suffocation hazard.
Connect illumination lamp-equipped speakers to DC 12V, negative ground.
Do not install speakers in locations subject to water or moisture.
Avoid installing speakers in unstable or dusty locations.
Do not open or modify the unit; it may cause fire hazard or malfunction.
Clean speakers by wiping with a soft, dry cloth, avoiding solvents.
Switch power OFF immediately if smoke/smell occurs and contact dealer.
Do not insert fingers into ventilation holes to avoid injury from VC coil bobbin.
Avoid touching hot speakers; do not install near fuel tanks due to fire hazard.
Use only 25A fuses; incorrect value may damage the speaker.
2-piece cone design using PBO fiber for high rigidity and minimal distortion.
2-piece anti-resonant design for improved sound quality and power handling.
Two magnetic circuits for improved linearity and accuracy of cone travel.
Dual dampers used for linearity and accuracy of cone travel.
Reduces vibrations and noise by minimizing basket movement.
Provides greater control for accurate bass response.
Maximizes heat dissipation for increased power handling.
Improves linearity and output while minimizing distortion.
Allows large gauge speaker wire and maximum signal transmission.
To Next Page