What to do if my Kenwood FPP210 processor stops during processing?
If your Kenwood Blender processor stops during processing, it might be overloaded or exceeding its maximum capacity. Refer to the recommended speed chart to verify that you are not exceeding the stated maximum capacities. Also, ensure that the lid is properly locked.
How to fix a Kenwood FPP210 Blender processor that won't operate?
If your Kenwood Blender processor will not operate, first, ensure that the processor is correctly plugged into a power source. Then, check that the bowl is correctly located with the handle situated towards the right-hand side, and verify that the lid interlock is correctly positioned into the handle area. The processor will not function if the bowl and lid are not correctly fitted. If these steps do not resolve the issue, inspect the fuse or circuit breaker in your home.
Why is my Kenwood Blender liquidiser or mini chopper/mill leaking?
If your Kenwood Blender liquidiser or mini chopper/mill is leaking from the blade assembly base, check that the seal is correctly fitted and undamaged. If the seal is damaged, you can find information on obtaining a replacement in the “service & customer care” section.
Why my Kenwood Blender processor will not operate?
If your Kenwood Blender processor will not operate, first, ensure it's plugged in and receiving power. Check that the bowl is correctly located with the handle on the right side and that the lid is properly locked into the handle area. The processor won't function if the bowl and lid aren't correctly fitted. If these steps don't resolve the issue, check the fuse or circuit breaker in your home.
Why is my Kenwood Blender liquidiser/mill leaking from blade assembly base?
If your Kenwood Blender liquidiser/mill is leaking from the blade assembly base, inspect the seal. Make sure it is correctly fitted and undamaged. For a replacement seal, refer to the service and customer care information.
What to do if Kenwood FPP210 liquidiser or mini chopper/mill will not operate?
If the Kenwood Blender liquidiser or mini chopper/mill will not operate, ensure that it is correctly locked onto the interlock. Also, verify that the blade unit is fully tightened into the goblet or jar.
What to do if my Kenwood FPP210 Blender liquidiser/mill will not operate?
If your Kenwood Blender liquidiser/mill won't operate, it might not be correctly locked or assembled. Ensure it is correctly fitted to the interlock and that the blade unit is fully tightened into the goblet or jar.
Safety precautions for the liquidiser, including scald risks.
Safety guidelines for the mini chopper/mill attachment.
Instructions for assembling and operating the main food processor unit.
Steps for assembling and using the liquidiser attachment.
A guide to diagnose and solve common appliance problems.
To Next Page
General