8
troubleshooting guide
Problem Cause Solution
T
he processor will not operate. No Power. Check processor is plugged in.
B
owl not fitted to power unit correctly. Check bowl is located correctly and
t
he handle is situated towards the
right hand side.
B
owl lid not locked on correctly. Check that the lid interlock is
located correctly into the handle
a
rea.
The processor will not work
i
f the bowl and lid are fitted
i
ncorrectly.
If none of the above check the
fuse/circuit breaker in your home.
Liquidiser or mini chopper/mill will not operate Liquidiser or mini chopper/mill not locked The liquidiser or mini chopper/mill will
on correctly. not operate if fitted incorrectly to the
interlock.
Liquidiser or mini chopper/mill not assembled Check blade unit is fully tightened
correctly. into the goblet/jar.
Processor stops during Processor overloaded/maximum capacities Check maximum capacities stated
processing exceeded. in the recommended speed chart.
Lid unlocked. Check lid is locked correctly.
Liquidiser or mini chopper/mill leaking from Seal missing Check seal is fitted correctly and not
blade assembly base. Seal incorrectly fitted damaged. To obtain a replacement
Seal damaged. seal see “service & customer care”
Poor performance of tools/attachments Refer to hints in relevant “using the attachment” section. Check attachments are
assembled correctly.
To Next Page
Loading...
