Need help?Do you have a question about the Kenwood G-EQ300 and is the answer not in the manual?
Audio Performance| total harmonic distortion at 1 kHz, Flat | 0.005% |
|---|---|
| frequency response | 10 Hz ~ 70 kHz, ±3 dB |
| signal to noise ratio (IHF '66) | 108 dB |
| graphic equalizer adjustment center frequencies | 40 Hz, 63 Hz, 98 Hz, 160 Hz, 250 Hz, 400 Hz, 625 Hz, 1 kHz, 1.5 kHz, 2.5 kHz, 3.9 kHz, 6.3 kHz, 10 kHz, 16 kHz |
| equalizer characteristic variable range | ±12 dB |
Impedance and Output| input impedance Line | 47 kΩ |
|---|---|
| maximum output voltage at 1% T.H.D. | 7 V |
| output impedance Line | 2.2 kΩ |
Power and Dimensions| power consumption | 18 W |
|---|---|
| dimensions | W: 400 mm (15-3/4") H: 141 mm (5-9/16") D: 375 mm (15-3/16") |
| weight net | 4.6 kg (10.2 lb) |
Covers voltage selection, mains plug information, and initial power-on safety.
Key safety warnings and caution symbols used in the manual.
Covers safe practices related to power sources, cords, shock hazards, and enclosure.
Guidelines on safe placement, temperature, moisture, and magnetic field exposure.
Protection against lightning, environmental hazards, and safe placement.
Guidance on servicing, parts, troubleshooting, and safety checks.
Details on equalizer level, effect, memory, genre selection, and frequency adjustment.
Instructions on how to cycle through graphic equalizer, spectrum analyzer, and demo modes.
Steps to create equalizer curves by setting center frequencies and levels.
Steps for adjusting additional center frequencies (F2, F3) and combining curves.
Fine-tuning equalizer curves for each frequency band in GRAPHIC mode.
Steps to save a created equalizer pattern using the MEMORY key and preset keys.
Selecting optimum playback patterns by music genre, tone, and purpose of use.
Steps to apply equalizer effect to cassette tape playback.
Steps to reset the microprocessor to factory condition in case of malfunction.
Table of common symptoms, their causes, and remedies for the unit.
To Next Page
