Need help?Do you have a question about the Kenwood KA-5011 and is the answer not in the manual?
Adjusts the power meter reading to 10W using VR3/VR4.
Component layout and identification for the preamp board.
Component layout and identification for the control board.
General| Dimensions | 440 x 137 x 349mm |
|---|---|
| Speaker load impedance | 4Ω to 16Ω |
| Type | Stereo Integrated Amplifier |
| Total Harmonic Distortion | 0.03% |
| Input Sensitivity | 0.2mV (MC) |
| Frequency Response | 5Hz to 100kHz |
| Signal-to-Noise Ratio | 86dB (phono MM) |
To Next Page
