Need help?Do you have a question about the Kenwood KAC-7251 and is the answer not in the manual?
Audio Output| rated power output (4Ω 20Hz~20kHz) | 150W x 2 (0.08% THD) |
|---|---|
| power output (4Ω DIN45324, +B=14.4V) | 150W x 2 |
| power output (2Ω 1kHz) | 230W x 2 (0.8% THD) |
| bridged power output | 460W x 1 (0.8% THD) |
| max power output | 800W x 1 |
Filters| low-pass filter | 50~200Hz (18dB/oct.) |
|---|---|
| high-pass filter | 150Hz (12dB/oct.) |
| bass boost circuit (KAC-7251) | OFF/+6/+9/+12dB |
| bass boost circuit (KAC-7201) | OFF/+12dB |
Performance Metrics| frequency response (0dB, -3dB) | 5Hz~50kHz |
|---|---|
| signal to noise ratio | 100dB |
| sensitivity (max.) | 0.2V (Rated Output) |
| sensitivity (min.) | 5.0V (Rated Output) |
| input impedance | 10kΩ |
General Specifications| operating voltage | 14.4V (11V~16V allowable) |
|---|---|
| current consumption (1kHz 10%THD) | 43A |
| installation size (W x H x D) | 285 x 57 x 305 mm |
| weight | 3.32kg |
Essential advice to prevent injury, fire, or unit damage during operation.
Guidance on cleaning, battery usage, and the unit's protection features.
List of accessories provided with the amplifier.
Critical advice on choosing installation spots and ensuring safe operation.
Sets the cutoff frequency for low-pass filtering.
Selects high-pass, low-pass, or no filtering for speaker outputs.
Controls the bass boost level manually or via remote.
Selects the amplifier's operating mode (Stereo or Mono).
Sets input sensitivity based on the center unit's output level.
Allows Bass Boost adjustment via remote for specific models.
Visual indicator for power status; absence may signal protection.
Lists specific conditions that activate the protection circuit.
Identifies and describes all input/output terminals on the amplifier.
Explains how to connect speakers and audio sources.
Step-by-step guide for installing the unit in a vehicle.
Best practices and warnings for wiring the amplifier.
Advice on choosing speakers based on impedance and power ratings.
How to connect audio sources using RCA or speaker level inputs.
Connecting the remote control for KAC-7251 models.
Illustrates stereo and bridged speaker wiring configurations.
Details on connecting the main power and ground wires.
Diagram showing a basic stereo amplifier setup.
Diagram for a bridged stereo amplifier setup for higher power.
Diagram for a system combining main speakers and a subwoofer.
Diagram and principle for tri-mode operation with crossover filters.
Potential causes and solutions for no sound or distorted audio.
Troubleshooting steps for when the remote controller does not work.
Detailed technical specifications for audio performance.
General operating parameters, dimensions, and weight.
Details of the limited warranty coverage, exclusions, and duration.
Instructions on how to get the product serviced under warranty.
To Next Page
