Kenwood KM003 User Manual

Please pick one of the following:
DISMANTLING AND RE-ASSEMBLING OF SOVEREIGN - KM001/002/003 AND
KM005/006/007
TOP COVER MOTOR
LATCH ASSEMBLY
PEDESTAL
GEARBOX SPEED CONTROL KNOB
TOP COVER
1. REMOVE ALL COVERS
2. REMOVE 4 SCREWS AND SPIGOTS
(NO.2 POZIDRIVE)
3. REMOVE SPIGOT PLATE
(A SMALL FLAT BLADED SCREWDRIVER
INSERTED BETWEEN THE PLATE AND THE
CASTING CAN BE USED TO EASE OFF THE
PLATE AROUND THE HIGH SPEED SPIGOT)
Page 1 of 11Spares - KM001/002/003/502/005/006/007/506 Disassembly & re-assembly instructio
...
30/04/2009http://www.kenwoodservice.co.uk/product-files-kar/soverei
g
n-tech2.htm

Kenwood KM003 Specifications

General

Brand	Kenwood
Model	KM003
Category	Food Processor
Language	English

Summary

Top Cover Disassembly and Re-assembly

Remove All Covers

Initial step to remove all covers from the top section of the appliance.

Remove Screws and Spigots

Procedure to remove four screws and associated spigots.

Remove Spigot Plate

Instruction to detach the spigot plate, using a flat screwdriver if needed.

Remove Additional Screws and Adjust Head Position

Remove three screws, raise the head, then remove two TX15 screws and lower the head.

Lift Off Top Cover

Instruction to lift the top cover from the high-speed outlet end of the casting.

Pedestal Disassembly and Re-assembly

Remove Pedestal Covers and Invert Appliance

Remove all covers from the pedestal and invert the appliance.

Remove Box, Cable Clamp, and Lid

Remove stuffer box screws, lid, fixing screws, box, cable clamp screw, and cable clamp.

Operate Head Release and Remove Fasteners

Disconnect Connectors and Remove Covers

Motor Disassembly and Re-assembly

Remove Top Cover and Washer

Remove Motor Screws and Belt

Remove Vent Panel and Motor