To Next PageTo Next Page
Need help?Do you have a question about the Kenwood KR-797 and is the answer not in the manual?
General| Type | Stereo Receiver |
|---|---|
| Frequency Response | 20Hz to 20kHz |
| Tuning Range | FM, MW |
| Input Sensitivity | 2.5mV (MM), 150mV (line) |
| Channel Separation | 50dB (1kHz) |
| Inputs | Phono, CD, Tuner, Tape |
| Signal to Noise Ratio | 100dB (line) |
Unit operating voltage settings and AC voltage selector switch explanation.
Warnings and precautions for safe operation and to prevent hazards.
Instructions for unpacking and listing included accessories.
Explains Dolby Pro Logic and Dolby 3 Stereo surround sound modes.
Describes the SRS 3D Stereo system for simulated 3D sound.
Diagram and instructions for connecting audio/video components to the KR-897.
Diagram and instructions for connecting audio/video components to the KR-797.
Guidelines for proper unit placement to ensure ventilation and prevent overheating.
Explains control modes, operations, and switching procedures.
Illustrates how to connect speakers to the KR-897 unit.
Explains which speakers are used for different playback modes.
Illustrates how to connect speakers to the KR-797 unit.
Explains the use of ADAPTOR jacks and shorting pins on the KR-797.
Instructions for connecting AM loop and FM indoor/outdoor antennas.
Explains the switch and its settings by region for optimal reception.
Identifies and explains the function of front panel controls, indicators, and standby function.
Describes remote keys, battery loading, and correspondence table.
Table of key functions and illustration of operating range.
Steps to power on, set speakers, and select audio input source.
Instructions for playing selected sources and adjusting volume.
How to adjust tone (bass, middle, treble) and speaker balance.
How to use Source Direct playback and the Natural Bass circuit.
Steps for connecting headphones and adjusting volume.
How to mute the sound temporarily using the remote control.
Steps to prepare for recording and select sources.
Instructions for copying tapes between decks.
Explanation of the TAPE 2 MONITOR function for comparison.
Steps to receive broadcast stations using tuner functions.
How to tune stations by entering their specific frequencies.
Procedures for storing, recalling, and cycling through preset radio stations.
How to use Dolby modes for immersive surround experience.
Guidelines for optimal placement of surround speakers.
How to select surround modes.
How to adjust front speaker balance.
How to calculate delay time and adjust speaker volume levels.
How to select surround modes, play sources, and adjust volume.
How to exit surround modes and return to normal stereo.
How to adjust the depth and expansion of SRS 3D Stereo effects.
Procedure to reset the unit's microcomputer to factory settings.
Common amplifier and tuner problems, causes, and remedies.
Troubleshooting steps when the remote control is not functioning.
Lists memory items cleared when power is disconnected.
Technical specifications for audio, tuner, and general aspects.
Technical specifications for audio, tuner, and general aspects.
Technical specifications for audio, tuner, and general aspects.
