EasyManua.ls Logo

Kenwood KSC-SW10 - User Manual

Kenwood KSC-SW10
10 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
In store "130" you
can find and buy almost all necessary goods for your auto
in
Kyiv and other cities, delivery by ground and postal services. Our experienced
consultants will provide you with exhaustive information and help you to chose
the very particular thing. We are waiting for you at the address
http://130.com.ua
PHONES
(044) 360-7-130
(050) 336-0-130
(063) 788-0-130
(067) 233-0-130
(068) 282
-
0
130
Internet store of
autogoods
CAR RECEIVERS — Receivers • Media receivers and stations • Native receivers • CD/DVD changers • FM-modulators/USB adapters • Flash memory • Facia plates and adapters • Antennas • Accessories |
CAR AUDIO — Car audio speakers • Amplifiers • Subwoofers • Processors • Crossovers • Headphones • Accessories | TRIP COMPUTERS — Universal computers • Model computers • Accessories |
GPS NAVIGATORS — Portable GPS • Built-in GPS • GPS modules • GPS trackers • Antennas for GPS navigators • Accessories | VIDEO — DVR • TV sets and monitors • Car TV tuners • Cameras • Videomodules
• Transcoders • Car TV antennas • Accessories | SECURITY SYSTEMS — Car alarms • Bike alarms • Mechanical blockers • Immobilizers • Sensors • Accessories | OPTIC AND LIGHT — Xenon • Bixenon • Lamps
• LED • Stroboscopes • Optic and Headlights • Washers • Light, rain sensors • Accessories | PARKTRONICS AND MIRRORS — Rear parktronics • Front parktronics • Combined parktronics • Rear-view mirrors
• Accessories | HEATING AND COOLING — Seat heaters • Mirrors heaters • Screen-wipers heaters • Engine heaters • Auto-refrigerators • Air conditioning units • Accessories | TUNING — Vibro-isolation
• Noise-isolation • Tint films • Accessories | ACCESSORIES — Radar-detectors • Handsfree, Bluetooth • Windowlifters • Compressors • Beeps, loudspeakers • Measuring instruments • Cleaners • Carsits
• Miscellaneous | MOUNTING — Installation kits • Upholstery • Grilles • Tubes • Cable and wire • Tools • Miscellaneous | POWER — Batteries • Converters • Start-charging equipment • Capacitors
• Accessories | MARINE AUDIO AND ELECTRONICS — Marine receivers • Marine audio speakers • Marine subwoofers • Marine amplifiers • Accessories | CAR CARE PRODUCTS — Additives • Washer fluid •
Care accessories • Car polish • Flavors • Adhesives and sealants | LIQUID AND OIL — Motor oil • Transmission oil • Brake fluid • Antifreeze • Technical lubricant
ICQ
294-0-130
597-0-130
SKYPE
km-130

Table of Contents

Questions and Answers

  • H
    hutchinsonlisaJul 30, 2025
    How to fix Kenwood Subwoofer if power cannot be turned on?
    • J
      Julie VelasquezJul 30, 2025
      If the power on your Kenwood Subwoofer will not turn on, there are several possible causes. Check if the fuse is blown. If it is, check the (+)/(-) polarity of the power cord and ensure the cords aren't shorted, then replace the fuse with one of the correct rating. Ensure the remote control cord is plugged into the REMOTE terminal. Check that the power supply pin (yellow) of the 10-pin connection cord is connected correctly. Finally, verify that the negative (-) cable of the car battery is connected.
  • A
    Angela BishopAug 9, 2025
    What to do if my Kenwood Subwoofer has no sound?
    • C
      Christopher MonroeAug 9, 2025
      If your Kenwood Subwoofer is producing no sound, several factors could be responsible. First, check if the attenuator of the center unit is set to ON and switch it OFF. Verify that the LEVEL control is not set to the MIN position, increase the volume to an optimum level. Also, ensure that the speaker cords and connection terminals are properly connected. Finally, ensure the remote control cord is plugged into the REMOTE terminal.
  • M
    Mia KentAug 14, 2025
    Why does my Kenwood Subwoofer sound unnatural?
    • S
      Stephanie McgrathAug 14, 2025
      Unnatural sound from your Kenwood Subwoofer can stem from several issues. Check that the speaker cords are connected with correct positive (+)/negative (-) polarity. Ensure the grounding pin (black) of the 10-pin connection cord has a good contact. Also, verify that the balance between the front speakers or between those and the rear speakers are well adjusted; adjust the tone balance by switching the PHASE switch to 0° or 180° as required.
  • W
    walsherikaAug 19, 2025
    What to do if my Kenwood Subwoofer sound is small?
    • J
      Joyce TranSep 12, 2025
      If the sound from your Kenwood Subwoofer is too quiet, it might be because the input level is set too low. Turn the LEVEL control knob to adjust the input level to an optimum level.
  • M
    maria11Aug 25, 2025
    How to increase the sound on my Kenwood Subwoofer?
    • D
      David PowellAug 25, 2025
      To increase the sound level of your Kenwood Subwoofer, turn the LEVEL control knob to set the input level to an optimum level, because the input level might be set too low.
  • R
    Rebekah BowersNov 3, 2025
    Why won't my Kenwood Subwoofer power on?
    • P
      Peter BoydNov 3, 2025
      If the POWER indicator of your Kenwood Subwoofer does not light up, preventing it from turning on, here are a few things to check: * A blown fuse could be the issue. Inspect the (+)/(-) polarity of the power cord, ensure the cords are not shorted, and replace the fuse with one of the correct rated capacity. Also, ensure the cords are correctly connected. * The remote control cord might be unplugged. Plug the cord into the REMOTE terminal. * The power supply pin (yellow) of the 10-pin connection cord might not be connected. Connect the cord correctly. Check all cord connections, then connect the (-) cable to the battery. Ensure the connector is fully inserted and the grounding terminal is attached to a metallic, uncoated section of the vehicle, tightly screwed in. * The negative (-...

Summary

Important Safety Instructions

General Warnings

General warnings for safe operation and potential hazards.

Precautions

Precautions to prevent damage or improper operation.

Connection

Installation

Operation

Remote Control Overview

Identification of buttons and indicators on the remote control.

Sound Adjustment

Explanation of how to adjust sound settings using the remote control knobs.

Troubleshooting Guide

Power Issues

Troubleshooting steps for when the unit does not power on.

No Sound

Troubleshooting steps for when there is no audio output from the unit.

Kenwood KSC-SW10 Specifications

General IconGeneral
TypeActive
Power Output150W
Speaker Size10 inches
RMS Power75W
Frequency Response30 Hz - 200 Hz
Driver Size10 inches
Enclosure TypeSealed
Low Pass Filter50Hz - 125Hz

Related product manuals