Do you have a question about the Kenwood R-SE7 and is the answer not in the manual?
rated power output (Class AB operation) | 20 watts per channel minimum RMS, both channels driven, at 6 Ω, 1 kHz with no more than 10% total harmonic distortion |
---|---|
rated power output (Class A operation) | 7.55 watts per channel minimum RMS, both channels driven, at 6 Ω, 1 kHz with no more than 10% total harmonic distortion |
total harmonic distortion | 0.02% (1 kHz, 10 W, 6 Ω) |
frequency response | 20 Hz ~ 40 kHz, +0 dB, -3 dB |
input sensitivity/impedance | 200 mV / 47 kΩ |
tuning frequency range | 87.5 MHz ~ 108 MHz |
---|---|
usable sensitivity (DIN) MONO | 1.2 µV (75 Ω) / 13.2 dBf (40 kHz DEV., S/N 26 dB) |
signal to noise ratio MONO | 65 dB |
signal to noise ratio STEREO | 58 dB |
selectivity (DIN ±300 kHz) | 64 dB |
tuning frequency range | 531 kHz ~ 1, 602 kHz |
---|---|
usable sensitivity | 15 µV (500 µV/m) |
signal to noise ratio | 48 dB |
output level/impedance | 0.18 V / 1 kΩ |
power consumption | 45 W |
---|---|
dimensions | W: 200 mm, H: 77 mm, D: 278 mm |
weight (net) | 3.0 kg |