What to do if I cannot talk to or hear other members in my group using my Kenwood TK-2102 Transceiver?
To ensure proper communication with your group on the Kenwood Transceiver, verify that you are using the same frequency and Quiet Talk tone as the other members. Also, make sure you are within range of the other transceivers, as distance can affect communication.
Why my Kenwood Transceiver has no power?
If your Kenwood Transceiver has no power, the battery pack may be dead or not installed correctly. Try recharging or replacing the battery pack. If that doesn't work, remove the battery pack and install it again to ensure it is properly connected.
Why does the battery power of my Kenwood TK-2102 die shortly after charging?
If the battery power of your Kenwood Transceiver dies shortly after charging, it's likely that the battery pack life is finished. Replace the battery pack with a new one.
How to remove other voices (besides group members) that are present on the channel of my Kenwood TK-2102 Transceiver?
If you are hearing other voices besides your group members on the channel of your Kenwood Transceiver, change the Quiet Talk tone. Be sure to change the tone on all transceivers in your group.
General| Frequency Range | 136-174 MHz |
|---|---|
| Number of Channels | 16 |
| Channel Spacing | 12.5/25 kHz |
| Power Output | 5W |
| Modulation | 16K0F3E / 11K0F3E |
| Type | Portable |
Lists the items included with the transceiver package, such as antennas, chargers, and manuals.
Instructions for charging the Nickel-Cadmium battery pack before initial use for optimal performance.
Prevents continuous transmission by stopping after a set period and sounding a tone.
Reduces power consumption when the transceiver is idle and not receiving signals.
Alerts operator of low battery via blinking LED and tone, stopping transmission.
To Next Page
