20
STATUS MESSAGES
You can transmit pre-programmed status messages by pressing
the keys programmed as [Status] and [Selcall + Status].
Status messages are 2-digit codes ranging from 10 to 99
(80 ~ 99 are reserved for special messages).
■
Transmitting
1 Select your desired zone and channel.
2 Press the key programmed as [Status] to enter Status
mode or [Selcall + Status] to enter Selcall mode.
• When using the [Status] key to enter Status mode, the
target Fleet/ ID is fixed and cannot be selected. Skip to
step 5 to continue.
3 Press the <B or C> key to select the ID of the station
you want to call.
• If your dealer has activated the [FleetSync (Selcall +
Status)] keypad operation and Manual Dialing is enabled,
you can enter the list number by using the keypad.
4 Press the S key to enter Status Mode.
5 Press the <B or C> key to select the status ID you want
to transmit.
• If your dealer has activated the [FleetSync (Status)] or
[FleetSync (Selcall + Status)] keypad operation and the
Manual Dialing is enabled, you can enter the list number
by using the keypad.
6 Press the PTT switch or Side 2 key to initiate the Status
call.
• “COMPLETE” appears when the call has been successfully
transmitted.
■
Receiving
The indicator will flash and a calling ID or text message
will appear when a Status call is received.
Press any key to return to normal operation.
To Next Page
Loading...
Need help?
General
