To Next PageTo Next Page
Need help?Do you have a question about the Kenwood TK-3160 and is the answer not in the manual?
Operating Environment| operating temperature range | –30˚C to +60˚C |
|---|---|
| frequency range | 450~490MHz (K, M), 470~512MHz (K2, M2), 400~430MHz (K3, M3) |
| channel frequency spread | 40MHz (K, M), 42MHz (K2, M2), 30MHz (K3, M3) |
Power| operating voltage | 7.5 VDC ±20% |
|---|---|
| battery life | More than 9 hours at 4 watts |
| rf power output | 4W/1W |
Receiver Specifications| sensitivity EIA 12dB SINAD | 0.25µV (Wide)/0.28µV (Narrow) |
|---|---|
| selectivity | 70dB (Wide)/62dB (Narrow) |
| intermodulation | 65dB (Wide)/62dB (Narrow) |
| spurious response | 65dB |
| audio power output | 500mW/8Ω |
Transmitter Specifications| spurious and harmonics | 70dB |
|---|---|
| modulation | 16KφF3E (Wide)/11KφF3E (Narrow) |
| fm noise | 45dB (Wide)/40dB (Narrow) |
| audio distortion | Less than 5% |
Weight and Dimensions| weight with KNB-24L battery | 290 g |
|---|---|
| dimensions with KNB-24L battery | 56 W x 109.3 H x 34.5 D mm |
| weight with KNB-25A battery | 355 g |
| dimensions with KNB-25A battery | 56 W x 109.3 H x 40.7 D mm |
| weight with KNB-26N battery | 400 g |
| dimensions with KNB-26N battery | 56 W x 109.3 H x 40.7 D mm |
Provides an overview of the service manual's scope and content.
Details the setup procedures for the transceiver's system.
Covers procedures for realigning the transceiver's functions.
Provides step-by-step instructions for disassembling the unit for repair.
Provides essential safety precautions for operating the equipment.
Describes the KPG-22 programming interface cable.
Details the KPG-82D programming software.
Details operations and procedures related to PC mode.
Instructions for separating the case assembly from the radio chassis.
Step-by-step guide to remove the battery terminal block.
Provides guidance on assembling components like battery block and speakers.
Instructions for separating the chassis from the TX/RX unit.
Instructions for assembling the chassis into the cabinet.
Details the frequency configuration of the transceiver.
Explains the function of the IF amplifier circuit.
Describes the receiver section, including front end and first mixer.
Describes the circuit for switching between wide and narrow modes.
General specifications including frequency range and channels.
Receiver specifications including sensitivity and selectivity.
Transmitter specifications including power output and modulation.
