Need help?Do you have a question about the Kenwood TM-733A and is the answer not in the manual?
General| Mode | FM |
|---|---|
| Output Power VHF | 50 W |
| Voltage | 13.8 VDC |
| Weight | 1.5 kg |
| Current drain RX | 0.5 A |
| Impedance | 50 Ω |
| Frequency Range RX | 118-174 MHz |
| Receiver Sensitivity | 0.16 μV (12 dB SINAD) |
Steps for safely installing the transceiver in a vehicle.
Instructions for connecting the DC power cable to the transceiver.
Procedure for replacing blown fuses in the power circuit.
Guidance on connecting the antenna system to the transceiver.
Connecting the transceiver to a regulated DC power supply.
Procedure for replacing blown fuses in the power circuit.
Connecting the antenna system to the transceiver.
Details on connecting external accessories like speakers and microphones.
Introduction to front panel, rear panel, and display functions.
Using 1 MHz and 10 MHz step functions for frequency adjustments.
How changing step sizes affects displayed frequency values.
Using the Push-to-Talk switch for transmitting.
Adjusting transmit power levels for communication efficiency.
Setting a maximum duration for a single transmission.
Configuring memory channel distribution between VHF and UHF bands.
Procedures for saving frequency and related data into memory.
Storing simplex frequency pairs for direct communication.
Storing split frequency pairs for repeater operation.
Retrieving stored data from memory channels.
Transferring memory channel data to the VFO.
Deleting data from memory channels.
Procedures for using and managing the Call channel.
Displaying memory channel numbers instead of frequencies.
Methods for resetting transceiver settings to defaults.
Troubleshooting common setup and usage issues.
Managing user preferences on a shared transceiver.
Adjusting settings for different mobile operating conditions.
Accessing programmable memory directly via front panel keys.
Accessing programmable memory using the tuning control.
Automatic offset programming for North American models.
Automatic offset programming for European models.
Disabling the automatic transmit offset feature.
Choosing subaudible tone frequencies for repeater access.
Automatically identifying incoming tone frequencies.
Storing DTSS codes using manual controls.
Storing DTSS codes via the microphone DTMF keypad.
Introduction to the Page function and its applications.
Managing and storing page codes.
An example illustrating group communication setup.
Storing page codes using manual controls.
Storing page codes via the DTMF keypad.
Receiving calls addressed to your specific station code.
Receiving calls addressed to a group code.
Setting up an audible alarm for incoming calls.
Customizing the alarm tone for incoming calls.
Configuring transmission speeds for packet radio communication.
Basic information on transceiver alignment and operation.
Procedures for returning the transceiver for repair or service.
Steps to open the transceiver case for installation access.
Instructions for installing the optional CTCSS unit.
Steps for installing detachable front panel kits.
Connection examples for detachable front panel kits.
General technical specifications of the transceiver.
Technical specifications related to the transmitter section.
Technical specifications related to the receiver section.
To Next Page
