Need help?Do you have a question about the Kenwood TM-702A and is the answer not in the manual?
General| Mode | FM |
|---|---|
| Supply Voltage | 13.8 V DC |
| Antenna Impedance | 50 Ω |
| Power Supply | 13.8V DC |
| Sensitivity | 0.16μV (12dB SINAD) |
| Intermediate Frequencies | 455 kHz |
Key notes for safe and proper use, including cautions and FCC requirements.
Technical details including frequency range, power, dimensions, and weight.
Steps for installing the transceiver bracket and unit in a vehicle.
Procedures for connecting the power cable to the battery and ignition.
Guidelines for fixed station power supply and antenna connection.
Detailed explanation of the function of each control and key on the front panel.
Explanation of various indicators and symbols displayed on the LCD screen.
Description of antenna connector, power input, fuse holder, and external speaker jack.
Functions of UP/DOWN switches, PTT, and CALL/1750 Hz keys on the microphone.
Steps to connect components and set up for receiving signals.
How to change operating frequency and adjust tuning/scan step size.
Enabling dual band reception and adjusting main/sub band volumes.
Procedures for transmitting, checking frequency, and duplex operation.
Memory backup, factory defaults, output power, and time-out timer settings.
Resetting the microprocessor to factory defaults.
Overview of memory channel capabilities and contents.
Step-by-step guide for storing frequencies and settings into memory.
Retrieving stored memory data and copying it to VFO.
Overview of different scan types like band scan and memory scan.
Managing scan pauses, resumes, and scanning frequency bands.
Scanning programmed frequency limits and memory channels.
Scanning alternate bands and locking out unwanted memory channels.
Setting repeater offsets and using the reverse function for repeater pairs.
Using sub-audible tones for repeaters and autopatch functions.
Enabling CTCSS for selective squelch operation.
Setting up and storing DTSS codes for selective receiving.
Selecting and storing DTSS codes in VFO or memory channels.
Using DTSS for normal operation and with repeaters, including delay settings.
Introduction to selective calling and group communication using paging.
Storing and selecting paging codes for individuals and groups.
Steps for initiating paging calls to individuals or groups.
Monitoring incoming pages and responding to calls.
Temporarily disabling paging codes to control squelch.
Setting up audible alarms for received signals, often used with CTCSS.
Configuring APO and adjusting display brightness.
Enabling/disabling beep tones and locking panel keys or all functions.
Guidelines for maintaining the transceiver and procedures for returning for repair.
Solutions for common problems like no sound, no transmit, or display issues.
Instructions for installing the CTCSS (TSU-6) and DTMF (DTU-2) units.
Functions and operation of the RC-10 remote controller.
Functions and operation of the RC-20 remote controller.
To Next Page
