Need help?Do you have a question about the Kenwood TM-731E and is the answer not in the manual?
General| Mode | FM |
|---|---|
| Channels | 1000 |
| Dimensions | 160 x 200 x 60 mm |
| Weight | 1.5 kg |
| Channel Step | 5, 10, 12.5, 15, 20, 25 kHz |
| Receiver System | Double conversion superheterodyne |
| Voltage | 13.8 V |
| Frequency Range | 144-146 MHz, 430-440 MHz |
| Sensitivity | 0.16 µV (12 dB SINAD) |
Critical safety precautions for operating the transceiver, including electrical shock and fire hazards.
Advice on avoiding direct sunlight, heat, and ensuring adequate ventilation for the transceiver.
Detailed technical data for transceiver models (frequency, impedance, power, dimensions, etc.).
List of accessories provided with the transceiver, such as microphones and cables.
Step-by-step guide for mounting the transceiver bracket securely in a vehicle.
Wiring and connection guidance for mobile installations, including antenna and speaker setup.
Detailed explanation of the main tuning control, keys, and indicators on the front panel.
Initial setup for receiving signals, including power, SQL, and balance control adjustments.
How to configure simultaneous dual band reception or single band reception modes.
Essential steps for transmitting, including antenna checks, frequency clarity, and power levels.
Setting up transmitter offsets and using the reverse function for repeater communications.
Procedures for using tone frequencies for repeater access.
Information on the internal battery for memory backup and how to reset the transceiver's memory.
Details on what data can be stored in each memory channel and their dual purposes.
Overview of available scan types: Programmable Band, Band, Memory Channel, and Double Scan.
Configuration of scan behavior, including Time Operate and Carrier Operate modes.
How the Tone Alert System provides audible alarms for signals on monitored bands.
Guidelines for routine maintenance, factory alignment, and when to contact service.
Instructions for safely cleaning the transceiver's knobs, front panel, and cabinet.
A table listing common problems, their probable causes, and recommended corrective actions.
Step-by-step guide for installing the optional CTCSS unit for tone squelch operations.
Instructions for connecting and configuring the RC-10 remote controller for basic reception.
How to perform duplex operations using the RC-10 with a single transceiver.
Listing and description of various microphones and the mobile antenna for the transceiver.
To Next Page
