Need help?Do you have a question about the Kenwood TS-530S and is the answer not in the manual?
General| Brand | Kenwood |
|---|---|
| Model | TS-530S |
| Category | Transceiver |
| Language | English |
Overview of the TS-530 transceiver's signal path and circuitry.
Details the signal flow from antenna to audio output in the receiver.
Describes the signal path from microphone to RF output in the transmitter.
Explains the frequency synthesis process using the PLL.
Illustrates component placement from the top of the unit.
Shows component layout from the bottom of the unit.
Component layout and view of the rectifier circuit board.
Component layout and view of the antenna relay board.
Component layout and view of the switch board.
Component layout and view of the final power amplifier unit.
Component layout and view of the VFO unit.
Component layout and view of the audio frequency unit.
Component layout and view of the intermediate frequency unit.
Component layout and view of the phase-locked loop unit.
Component layout and view of the radio frequency unit.
Component layout and view of the frequency counter unit.
Lists the necessary test equipment for calibration and alignment procedures.
Specifies default control settings before starting adjustments.
Shows signal levels in the receiver circuitry.
Illustrates signal levels in the transmitter circuitry.
Circuit diagram for the VFO-240 unit.
Circuit diagram for the AT-230 unit.
Lists required test equipment for AT-230 adjustments.
Procedure to adjust the power meter on the AT-230.
Steps to calibrate the reference power for the AT-230.
To Next Page
