Need help?Do you have a question about the Kenwood TS-830 and is the answer not in the manual?
General| Type | HF Transceiver |
|---|---|
| Frequency Range | 160-10 meters |
| IF Frequencies | 8.83 MHz, 455 kHz |
| Modes | AM, CW, SSB |
| RF Output Power | 200 watts PEP SSB/CW, 80 watts AM carrier |
| Receiver Sensitivity | 0.25 µV for 10 dB S+N/N |
| Image Rejection | >70 dB |
| IF Rejection | >80 dB |
| Audio Output | 2.0 Watts into 8 Ohms |
| Tuning Steps | 100 Hz |
| Power Supply | 13.8 V DC |
Crucial initial instructions for safe operation and setup.
Overview of document evolution and planned updates.
Detailed overview of the radio's features, performance, and accuracy.
Fixes for amplifier relay control signal delays causing hot switching.
Solutions for various frequency drift and jumping problems.
Resolving intermittent ALC issues and improving audio crispness.
Diagnosing and fixing lack of power output and power drop-off.
Addressing issues like pilot lamp burnout and relay failures.
Troubleshooting signal attenuation, AGC overshoot, and TV interference.
Resolving problems arising after QRO modifications or transmitter talkback.
Practical advice from users on high voltage, sidetone, tube differences, and more.
Diagnosing drive control problems and intermittent loss of drive.
Addressing low output on 160m and FIX band crystal selection.
Guidance on tube replacement, drive settings, and model differences.
Fixing TX relay chatter and WARC band operation.
Resolving receiver signal attenuation and VOX trip issues.
Proper lubrication for VFO and cooling fan components.
Aligning VBT and Carrier Oscillators for optimal signal processing.
Implementing AMTOR and WARC band modifications.
Adjusting RIT/XIT, VFO tuning, and improving low voltage supply.
Modifying filters, enabling 240V AC operation, and noise blanker improvements.
A compilation of user experiences and ratings for the TS-830S.
Pin assignments for the 4-pin microphone plug.
Pin assignments for the 7-pin remote control plug.
To Next Page
