Need help?Do you have a question about the Kenwood TS-430S and is the answer not in the manual?
Describes the controls and indicators on the front and top panels of the TS-430S transceiver.
Details the connectors and controls located on the rear panel of the TS-430S.
Instructions and settings for receiving signals with the TS-430S transceiver.
Procedures and settings for transmitting using the TS-430S transceiver.
Instructions for connecting and operating a linear amplifier with the TS-430S.
Details on operating the transceiver in CW mode, including tuning.
Guidance for installing and operating the TS-430S in a mobile environment.
Information on power and antenna setup for fixed station operation.
Describes the controls and indicators on the front and top panels of the TS-430S transceiver.
Details the connectors and controls located on the rear panel of the TS-430S.
Instructions and settings for receiving signals with the TS-430S transceiver.
Procedures and settings for transmitting using the TS-430S transceiver.
Instructions for connecting and operating a linear amplifier with the TS-430S.
Details on operating the transceiver in CW mode, including tuning.
Guidance for installing and operating the TS-430S in a mobile environment.
Information on power and antenna setup for fixed station operation.
General| Power Supply | 13.8 VDC |
|---|---|
| Antenna Impedance | 50 ohms |
| IF Frequencies | 8.83 MHz, 455 kHz |
| Modes | AM |
| IF Rejection | Better than 80 dB |
| Audio Output | 2 W into 8 ohms |
| Frequency Range | 160-10 m + WARC |
| Image Rejection | >70 dB |
To Next Page
