Need help?Do you have a question about the Kenwood TS-811E and is the answer not in the manual?
General| Power Supply | 13.8 VDC |
|---|---|
| Modes | CW, FM |
| Tuning Steps | 5 kHz, 10 kHz, 12.5 kHz, 20 kHz, 25 kHz |
| Dimensions | 290 mm |
| Image Rejection | Greater than 60 dB |
| IF Rejection | More than 70 dB |
| Selectivity | 12 kHz at -6 dB |
Describes power switch, S meter, display, and CH.Q switch.
Details MIC, RF PWR, SQL, IF.SHIFT, RIT, AF/RF controls.
Explains VOICE, NB, DOWN/UP, COM, VFO/M, FUNCTION switches.
Details Main Dial control and MODE/keys (1-0).
Explains DCS switch, D.SQ, CS, and C.AL switches.
Describes PHONE jack, MIC connector, ACC, ALC/RF, PROC, RPT switches.
Lists rear panel connectors, indicators, and voltage selection.
Automatically selects the proper mode for the frequency segment.
Explains audio feedback via beep sounds for input functions.
Step-by-step guide for operating in FM mode.
Details reception and transmission procedures for SSB.
Explains transceiver usage for CW communication.
Guidance on using the transceiver for satellite communication.
Covers RIT, IF SHIFT, and RF Gain controls.
Details RF PWR control and auto reset thermal protector.
Details memory channels, contents, and entry procedures.
Explains program scan, memory scan, and mode scan.
Covers scanning all memory channels and locking out channels.
Describes activating alert circuit to monitor memory channel 1.
Outlines DCS features like coded squelch and call sign entry.
Procedures for entering call signs and digital codes.
How to use stored digital codes for transmission.
Explains standby indicator, activation, and squelch operation.
Details antenna, connections, ground, and power for fixed stations.
Covers vehicle mounting, antenna, power, and noise suppression.
Adjusting beep sound volume and main dial torque.
Procedure to monitor call sign with optional display.
Adjusting side tone volume and replacing backup battery.
Procedures for resetting the microprocessor and ACC jack usage.
Lists common symptoms, causes, and remedies for transmitter/receiver problems.
Lists various optional speakers (SP-430) and microphones (MC series).
Details VS-1 voice synthesizer and TU-5 subtone unit.
Covers DC cable, call sign display, and headphones.
Explains signal paths for reception and transmission.
Details the RF amplifier and mixer circuits.
Covers IF reception and transmission systems, noise blanker, and squelch.
Explains microphone amplifier, processor, and other circuits.
Describes the final amplifier, voltage regulator, and PLL circuits.
Explains the processing of digital control signals for DCS.
To Next Page
